Installation Instructions
Average Repair Rating: 4.4 / 5.0, 4 reviews
?
Sort by:
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
James from Rapid City, SD
Upper prong on striker broke. Washer door would not close
Remove two screws holding Door Strike in place. Remove old striker. Install new striker reinstalling two screws
1 person found this instruction helpful.
Thank you for voting!
Arthur from New Castle, DE
Door would not close/latch.
Removed door from washer. With door on flat surface all the screws are easily removed to replace striker & door hinge/ bushings. Pay attention to bushings position when removing so as to replace them in the same position. Video shows a guy pulling the door gasket off to replace the door lock & switch assembly. Skip that & remove the top cover from the washer. Only two screws in the back hold it on & it's a lot easier to reach inside & pull the switch up than fighting with the door gasket. With the new door hinge, door closes easier & more solid than when brand new. Easy fix.
1 person found this instruction helpful.
Thank you for voting!
John from Gloucester City, NJ
The locking tang on the door striker broke off due to door misalignment.
Removed the two philips head screws holding the door striker on the door and installed the new striker with a number 2 phillips head screwdriver.
0 of 1 people found this instruction helpful.
Thank you for voting!
Richard P from Butler, PA
Broken door striker
Replaced the striker & the door lock assembly in less than ten minutes. The shipping notification email had a link to an installation video that was spot on. Will order here again.
0 of 1 people found this instruction helpful.
Thank you for voting!
Sorry, we couldn't find any existing installation instruction that matched.