OEM Frigidaire Washer Front Load Washer Door Lock and Switch Assembly [131763256] | Ships Today | Fix.com
Front Load Washer Door Lock and Switch Assembly – Part Number: 131763256
Front Load Washer Door Lock and Switch Assembly – Part Number: 131763256 Front Load Washer Door Lock and Switch Assembly – Part Number: 131763256 Front Load Washer Door Lock and Switch Assembly – Part Number: 131763256 https://fixcom.azureedge.net/Schematics/Frigidaire/S8VCFRUN.gif

Front Load Washer Door Lock and Switch Assembly

Your Price
$87.21

Fix Number: FIX12364048

Manufacturer #: 131763256

Manufactured by: Frigidaire

Works with the following brands

Frigidaire, Kenmore, Crosley, Gibson, Westinghouse, Electrolux

Works with the following products

Washer, Washer Dryer Combo

Fixes the following symptoms

Will Not Start | Pumps but will not spin | Lid or door won’t close | Will not drain

Videos For installing this part.

Installation InstructionsProvided by FIX customers like you

Average Repair Rating: 4.2 / 5.0, 16 reviews ?
Sort by:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
KERRY from AURORA, CO
Parts Used:
131763256
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers
Wouldn't Lock (Door). Light Wouldn't Come On For Door Lock.
Watched a vidio from frigidaire . Unplugged washer !!! Removed locking ring on outside of the rubber boot. Peeled the boot open (only by the door lock area) removed two door lock screws. Unplugged three wire connectors. Replaced lock. Reassembled. Plugged back in. Works great!
4 of 4 people found this instruction helpful.
Were these instructions helpful?
Customer:
Howard from Santa Rosa, CA
Parts Used:
131763256, 131763310
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
door ajar alarm
myself and it was easy , as the diy video described on your website
1 person found this instruction helpful.
Were these instructions helpful?
Customer:
Micahel from Plymouth, IN
Parts Used:
131763256
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Front loading washer would drain but not spin (drum still turned, though).
Removed the metal collar (the spring is at the bottom under the lip of the seal; just stretch the spring with some pliers and remove the ring) holding the door seal on. Pulled out the side of the door seal covering the lock mechanism (not the whole seal). Unscrew the two screws in the latch, pull out the mechanism, unplug the connectors, then install the new mechanism by reversing the process. Problem solved in 10 minutes.
1 person found this instruction helpful.
Were these instructions helpful?
Customer:
Emma from AZLE,, TX
Parts Used:
131763256
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
My front load washer would not spin.
After receiving the part I decided not to follow the direction of the video that was suggested. Instead, I removed the top of the washer by removing the two screws that hold it on. I unplugged the washer. Then I removed the two screws in the front of the washer that held the part in. I reached down through the top of the washer, grabbed the part, unplugged all the wires, took the new part, plugged all the wires into it. Put it back in place, re-installed the screws in the front of the washer that keeps the part in place. Put the top of the washer back where it belongs and screwed it in place. I was done in less than fifteen minutes. I found this way to be little better for me because I did not have to take the seal off the washer drum. I was concerned that I would damage the seal.
1 person found this instruction helpful.
Were these instructions helpful?
Customer:
Arthur from New Castle, DE
Parts Used:
131763302, 131763256, 134550800
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers
Door would not close/latch.
Removed door from washer. With door on flat surface all the screws are easily removed to replace striker & door hinge/ bushings. Pay attention to bushings position when removing so as to replace them in the same position. Video shows a guy pulling the door gasket off to replace the door lock & switch assembly. Skip that & remove the top cover from the washer. Only two screws in the back hold it on & it's a lot easier to reach inside & pull the switch up than fighting with the door gasket. With the new door hinge, door closes easier & more solid than when brand new. Easy fix.
1 person found this instruction helpful.
Were these instructions helpful?
Customer:
Robert W. from Fort Pierce, FL
Parts Used:
131763256
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
door would not lock or start
1 Unplug washer. 2 take a hold of spring at bottom of rubber door seal pull spring to right slipping the retainer loop wire out and away from seal.3 pull seal away from.the opening to allow you to reach in to the switch. remove two screws holding the switch in place. remove three plugs from switch assembly and replace switch. Install in reverse order. door seal a little tricky reattaching to rim.
0 of 1 people found this instruction helpful.
Were these instructions helpful?
Customer:
Richard from Santee, CA
Parts Used:
131763256
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Door lock went bad and the washer would not start.
I took the lower front panel off and took the 2 screws off the switch assembly, then reach up inside and disconnect the 3 wire sets. remove the assembly. before putting in the new unit in, it helps to screw the screws in and out of the unit first it makes it easier to put them in when you install the unit. to make it easier to install I took a small piece of 2 x 4 and pushed the tub back and put the 2 x 4 between the tub and the front of the washer. install the unit remove the 2 x 4 reinstall the front panel and your done.
0 of 1 people found this instruction helpful.
Were these instructions helpful?
Customer:
karen from Lake View, NY
Parts Used:
131763256, 134190200
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers
front load washer would start to wash then stop agitating.
We followed video instructions provided by this site repair for the water inlet valve. We continued with door lock assembly by working through top of machine instead of taking off rubber seal. This was an option that video suggested but did not show. Washer was repaired and is now working just fine. Thank you for providing video.
0 of 1 people found this instruction helpful.
Were these instructions helpful?
Customer:
L. from Vestal, NY
Parts Used:
131763256
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Washer would not go into spin mode regardless of settings.
The video for changing the Door Lock and Switch Assembly helped, but I could not remove the rubber gasket of the front loader, as it showed there. But it was easy to slide off the top of the washer after removing two screws (unplug the washer first). Then you can unscrew the old Assembly (Part No. PS2367737). To unplug the wires and get it out, you have to snake your arm down the inside front. Someone with thin arms can do it best. Then connect the wires to the new part (easy), snake it back down in place, and screw it in as the video shows. Slide the top back on, and put the screws back on. It works great again!
0 of 1 people found this instruction helpful.
Were these instructions helpful?
Customer:
michael from chester, VA
Parts Used:
131763256
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers
Timer would not advance
Unplug or throw breaker on power.Remove two screws below dryer remove panel.Slid top of washer forward no screws set aside.Reach down unplug wires from switch.Remove screws from switch careful not to drop front panel at bottom is removable in case you do.Reassemble in opposite of directions. Close quarters plugging up switch but can be done
0 of 1 people found this instruction helpful.
Were these instructions helpful?

Model Cross Reference

This part works with the following models:

Fix Number: FIX12364048
Manufacturer Part Number: 131763256
Brand
Model Number
Description
Frigidaire
38712
Washer - WASHER
Frigidaire
38802
Washer - WASHER
Kenmore
41724182300
Washer
Kenmore
41724182301
Washer
Kenmore
41727182700
Washer
Kenmore
41727182701
Washer
Kenmore
41727182702
Washer
Kenmore
41727182703
Washer
Kenmore
41727182704
Washer
Kenmore
41729022890
Washer
Kenmore
41729042992
Washer
Kenmore
41729052991
Washer
Frigidaire
41739012890
Washer - Stackable
Frigidaire
41739012891
Washer
Frigidaire
41739022890
Washer
Frigidaire
41739022891
Washer
Kenmore
41740032990
Washer
Kenmore
41740042990
Washer
Kenmore
41740052990
Washer
Kenmore
41740142000
Washer
Kenmore
41740412700
Washer
Kenmore
41740412701
Washer
Kenmore
41740412702
Washer
Kenmore
41740412703
Washer
Kenmore
41741042000
Washer
Kenmore
41741052000
Washer
Kenmore
41741142000
Washer
Kenmore
41742042100
Washer
Kenmore
41742052100
Washer
Kenmore
41742142100
Washer