This temperature sensor detects the temperature within the oven cavity.
Works with the following brands:
KitchenAid, Whirlpool, Jenn-Air, Maytag
Works with the following products:
Wall Oven, Range, Microwave Oven Combo, Cooktop
Fixes the following symptoms:
Oven is too hot, Little to no heat when baking, Oven not heating evenly, Will Not Start
Part# WPW10131825 replaces these:
AP6015486, 4455636, W10131825, WPW10131825VP
Videos For installing this part.
Replacing your Temperature Sensor
Questions and Answers
Ask our experts a question about this part and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched. Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Mike
December 3, 2021
My oven is not heating properly. I have checked every element for continuity and they all read less than 1 ohm. So I am checking my temperature sensor from the back of the panel and it has a small plug on it. My multi-meter's probes are too big to get into the plug. Do you have any suggestions on how to check the resistance on the temperature sensor?
For model number KERA807PSS02
Hello Mike, Thank you for the question. The only way to test the resistance is with the Multimeter. If the probes are too large, a different meter would be needed. We hope this helps!
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
Something went wrong. Please try again later.
Your Question Has Been Submitted!
Our experts will send you an email as soon as your question has been answered.
Installation Instructions Provided by Fix customers like you.
Average Repair Rating: 4.3 / 5.0, 3 reviews.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
I removed the 2 screws that held the sensor in and pulled it forward and unplugged the connector. I plugged in the new sensor and replaced the 2 screws that had been remove. It was done in about 5 minutes or less.
Turned power off and unplugged from outlet. Opened door and took Philip screwdriver and removed two screws. Very slowly pulled sensor out and unplugged connector.connected new sensor and installed it back to oven. Plugged back in outlet and turned power back on.
2 of 2 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
Next >
Model Compatibility
This part works with the following models:
Fix Number: FIX11748765
Manufacturer Part Number: WPW10131825