Canister Vacuum Belts

Fix Number

FIX12066418

Manufacturer Part Number

H-38528011

This belt is an OEM direct from Hoover. The rubber composite belt is compatible with a variety of vacuum models, and is sold individually. This part transfers power from the motor to the brush roll assembly. You will need a screwdriver for the installation.

Fix Number

FIX4133814

Manufacturer Part Number

6602-001423

Fix Number

FIX10270195

Manufacturer Part Number

B-160-1961

This is an authentic Bissell replacement part manufactured for use with upright vacuums and carpet cleaners. The belt is used as an actuator between the motor and brush roll. The belt drives the brush in a spinning motion to help lift dirt into the vacuum. Belts do wear out over time from normal use and need to be replaced occasionally. This belt is sold individually.

Fix Number

FIX16593716

Manufacturer Part Number

166124-3

Fix Number

FIX16621887

Manufacturer Part Number

6602-004036

Fix Number

FIX17016360

Manufacturer Part Number

E-77133

Poly V5 Belt

Fix Number

FIX10473206

Manufacturer Part Number

RO-672260

This is a belt for your vacuum. It rotates the brush roll assembly that is used to collect dust, hair, and other small debris. The belt is located and installed in various places, depending on your model. Because it is constantly working when your vacuum is running, the belt is a commonly replaced part. It is sold individually, however, we recommend buy two at once to keep an extra on hand.

Fix Number

FIX12066424

Manufacturer Part Number

H-38528036

This replacement drive belt is specially manufactured for Hoover vacuums. It is an authentic OEM sourced replacement part, not an aftermarket alternative. It is the belt that would spin the brush roller. Over time rubber belts tend to stretch and wear our requiring replacement. It is recommended to replace these belts every 6 months to ensure top performance. Please note, this belt is sold individually. Replacing this belt is a simple job that only requires a screwdriver. • Remove the bottom plate • Remove the brush roller and the old belt • With lettering on outside of belt slide new belt over motor pulley • Insert agitator through belt and place belt in belt guide on an agitator • Grasp agitator firmly and fit it into position • Turn agitator making sure belt is not pinched between agitator and agitator shield • Reassemble and test the unit

Fix Number

FIX3577931

Manufacturer Part Number

4400FI4001A

Fix Number

FIX4242538

Manufacturer Part Number

DJ61-00046A