Part Location Diagram of 243710-00 DeWALT Power Cord
See part 72 in the diagram
( Grid squares measure 1x1 inch )

Power Cord 243710-00

★★★★★
★★★★★
1 Review

Rated by 1 customers 

?

A Bit Difficult 

30 - 60 mins 

Ratings submitted by customers like you who bought this part.

?
$6.51
In Stock
Fix Number:
FIX11925320
Manufacturer #:
243710-00
Manufactured by:
DeWALT

Product Description

This is a genuine manufacturer-sourced part which is specially designed for use with DeWALT and Black and Decker landscape edgers. The cord is hardwired to the tool in order to supply power from a standard U.S. outlet, unfortunately, over time it may wear out, get damaged or lost eventually requiring a replacement. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this component. Keep in mind this high-quality item is made of durable materials and is sold individually.

Questions and Answers

Be the first to ask our experts a question about this part!

Installation Instructions Provided by Fix customers like you.

Average Repair Rating: 2.8 / 5.0, 1 reviews.
  • 1
Sort by:
Sorry, we couldn't find any existing installation instruction that matched.
Customer:
Bruce from New Berlin, WI
Parts Used:
243710-00
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers
Replacement of Damaged Power Cord
Using the correct Torx driver, remove the handle and hand guard. With the same Torx driver, remove all case screws. Lay the case on one side and carefully split the case. Remove the cord hold-down strap. (In my case, the power cord connectors did not exactly match the existing connectors.) Cut the existing connectors from the old power co rd allowing sufficient length to splice to the new cord. Carefully strip the insulation (approx 1/2") from the ends of the old and new wires being careful to match the black and white wires. Insert one end of the stripped wire through appropriately sized heat-shrink insulation. Solder the exposed wire ends. Slide the insulation over the soldered joint and apply heat to shrink (or wrap with electrician's tape). Push the wires into the case and re-install the hold-down strap. Position the rubber strain-relief fitting into the handle of the case. Replace the case halves being careful to not pinch the wires. Reseal the case with the Torx screws. Attach the handle and hand guard using the Torx screws. Test the repair.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
  • 1
Customer Reviews
Average Rating: (1 Review)
5.0
★★★★★
★★★★★
Filter By Rating:
  • 1
Sort by:
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.

Model Compatibility

This part works with the following models:
Fix Number: FIX11925320
Manufacturer Part Number: 243710-00
Brand Model Number Description
Black and Decker EH1000 Hedge Trimmer - 12 AMP Lawn Edger
Black and Decker EH1000LW Edger - Edgehog Lawn Edger - Lowe
Black and Decker LE710 Edger - 10amp 2in1 Ldsc Edgr
Black and Decker LE750 Trimmer - EDGE HOG 2-in-1 Landscape Edger