KitchenAid Wine & Beverage Cooler Parts
Start With Your Model Number
Find Parts Fast
Guaranteed Fit
Repair Videos
Need help finding your model number?

Popular KitchenAid Wine & Beverage Cooler Parts
$16.32
In Stock
Light Bulb - 10W
Fix Number FIX11739347
Manufacturer Part Number WP22002263
This ten watt appliance light bulb is two inches tall. It is used with both washers and dryers.
Installation Instructions
David from Myrtle Beach, SC
Dryer would squeek loudly
Removed door, and front bezel. Write the colors of the wires next to the door switch and the moisture sensor on the bezel so that you can remove the wires, this makes it easier. Lifted top up and pulled drum out, but did not remove belt. Inspected wheels and roller shaft. Needed to replace (2) Roller Wheels, (1) Roller Shaft, (2) Retaining Rings, & (2) Shaft Washers. Ordered parts from the site. Removed the Retaining rings. The retaining ring tool I bought from the hardware store did not fit the holes in the retaining ring, so I had to file the tips down. Once the retaining rings are removed, the washers and rollers come off easily. The Roller Shaft can be removed by loosening the nut on the back side of the shaft. Inserted new shaft and tightened nut, then replaced both rollers, and washers, and reinstalled the Retaining rings. Put drum back in place, tied all wires back in and reinstalled front bezel and door.
Read more...
GASKET / BLACK
Fix Number FIX11750827
Manufacturer Part Number WPW10238068
This door gasket is used to make an air-tight seal for the cabinet when the door is closed.
TIMER-DEF
Fix Number FIX16744893
Manufacturer Part Number W11609704
This device acts like a clock. It continually advances and alternates between activating the cooling cycle and the defrost heater.
Thermostat Kit
Fix Number FIX11742385
Manufacturer Part Number WP4344659
Used in wine cellar appliance. * Parts included in this kit may differ in appearance, but functions the same as the original part.
The temperature control thermostat regulates the temperature inside the refrigerator. It turns on and shuts off the compressor as needed to maintain the set temperature
Fixes these symptoms
- Fridge too warm
- Will Not Start
- See more...
Installation Instructions
Michael from Pipersville, PA
Thermostat went bad, water leaked everywhere
Removed back panel, then removed grate and control knob on lower front of cooler. Take out 2 screws holding in the thermostat (control knob connected to this piece). Locate wire in back, end goes through insulation to fridge compartment. In back of fridge, remove screws and panel to reveal the thermostat end. Connect new parts as directed - found an installation video on YouTube to educate me - and replaced all of the pieces.
Read more...