Armature 2610004634
- Fix Number:
- FIX10259909
- Manufacturer #:
- 2610004634
- Manufactured by:
- Dremel
Jump to:
Product Description
It is a genuine OEM sourced replacement part that is designed for use with Dremel rotary tools. This item includes an armature, fan, armature bearing and commutator end bearing. You'll need to replace the armature if you notice smoke or sparks coming from the vents on the back of your tool. If this happens, you've probably overloaded your armature and some point, which caused the insulation to break down. It is highly recommended to replace both carbon brushes when replacing an armature.
-
Works with the following brands:Dremel, Bosch
-
Works with the following products:Router, Hammer Drill, Multi-Tool
-
Part# 2610004634 replaces these:2610004634
- Works with the following brands:
- Dremel, Bosch
- Works with the following products
- Router, Hammer Drill, Multi-Tool
- Part# 2610004634 replaces these:
- 2610004634
Questions and Answers
Ask our experts a question about this part and we'll get back to you as soon as possible!
- < Prev
- 1
- Next >
Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!

Related Parts Additional or alternate parts to consider.
Installation Instructions Provided by Fix customers like you.
- < Prev
- 1
- Next >
- Customer:
- PHILIP from MESA, AZ
- Parts Used:
- 2610004634
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
2/ Pry off wire suspension loop from rear of tool.
3/ Remove the commutator brushes.
3/ Remove Torx screws holding the two halves of the tool together.
4/ Gently pry apart the two halves of the tool. Leaving the all the components in the half that has the Dremel ... Read more label.
5/ Carefully lift the armature aft end out of the housing and gently pull out the armature assembly.
6/ Reinstall the new armature and make sure it rotates freely and the stator housing is seated in the plastic housing. Double check the brush holders are seated correctly.
7/ Reinstall the screws, suspension loop and nose ring.
8/ Install new brushes. Don't reuse the old ones.
9/ Double check armature rotates freely by hand before applying power.
10/ All done.
- < Prev
- 1
- Next >
Model Compatibility
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.