SPRING- CH

Removed the Drip tray and removed the two hex screws at the bottom with a nut driver. detached the face plate by pushing up. (pops off) Removed the two hex screws securing the dispenser assembly and pulled it out to access the wiring to the control board. Unplugged the wiring and removed the control panel and face plate to access the paddle/spring assembly. Used the needle nose pliers to remove the spring from the paddle assembly, popped out the paddle where it snaps in on the side opposite the spring. Fish the spring end of the paddle out of the pivot hole and reinstall the new paddle unit and spring by reversing the above process. Reassemble the wiring harnesses onto the control board and attach the ice/water assembly with the two hex screws at the top using the nut driver. Replace the face plate and reinstall the two hex screws at the bottom. Snap the face plate back into place and replace the drip tray.