Have you ever purchased from us before?
Thank you for helping make our site better.
Manufacturer #: WR23X10725 /
Manufactured by: GE /
Fix #: FIX8758429
Manufacturer #: WR23X10725 |
Manufactured by: GE |
Fix #: FIX8758429
Followed the video with no problems, but the door would not close. There is a rubber bumper that the light switch strikes, This bumper was not horizontal, and just had to be twisted to a horizontal position. The door then closed tightly, Total repair time was about 5 minutes!
Were these instructions helpful?
It was basically the same as your video. I unplugged the fridge, pried off the previous switch and moved the electrical leads from the old switch to the new one. Everything worked great. The only issue (if you want to call it that) was that prying the old switch out bent the edge of the opening and needed to be tapped back. But it was easy and quick.
Getting out the old part was a little challenging. Rocking the part back and forth and pulling it out gradually with a little help from a small flathead screwdriver finally worked. Once the old part was unplugged from the internal wiring, replacement was easy. I simply plugged in the new part, popped it into the upper door of the refrigerator, and snapped it into place. Nothing could be easier.
Same as all the instructions, but I think it's important to know that the plug in looks like the backing to a stud earring. You have to slide the prongs underneath the flat part. Not your regular plug-in. I'm 59, and that's the first time I ever saw such a thing.
video on web site very helpful. unplug power,remove old switch, install new switch. But after installing new switch it did the same thing that the old one did. i.e. prevent the door from closing. That's how I broke the old one by forcing it shut. I learned that the door stud that should hit the switch was hitting it too low to engage the switch, probably due to door sag. I had to carefully remove the new switch without breaking it ( its kind of fragile) and flip it upside down to work properly. Caution: do unplug the power as I did not and caused a spark, which scared the crap out of me. Luckily no damage to the unit but a blackened area on the switch.
Watched a video on u-tube. It took longer to move and unplug the fridge than it did to make the repair. Anyone can do this. Don't waste your money on a repair man!
just poped it out with screwdriver but i would recomend that you unplug refridg first,i did not and shorted out when removing old sw.---karl
Ordered and replaced light switch and socket. Installed new bulb. Adjusted contacts in socket. Checked wires in back, vacuumed, Light still doesn't work. However replacing switch and socket was easy. Parts arrived fast.
I unplugged the power cord from the outlet before working on the switch. It was a little difficult getting the old switch out of the side panel of the refrigerator door. The release clip on the old switch was inside the door and I needed to use a small thin screwdriver to push down the clip and pop it out of side panel. The switch wires did not clip onto the new switch very well. They were too loose and would not clip onto the switch prongs. I had to crimp the wire prongs closed a little so that they snapped onto the metal prongs of the switch tightly. I powered up the frig and tested the light switch to ensure it was working before re-installing it into into the side panel The repair took about 15-20 minutes to complete and I had a few frustrating moments.
ADHD is a disorder that can be plagued with negative stigmas, but…