Front Burner Igniter/Orifice Assembly - 14K

Hardest part was figuring out how to get the range top off. 1 - Remove burner grates, caps and burner heads. 2 - Remove the two screws from each burner assy. 3 - Slide a small pry bar or screwdriver between the range top and side of the range and the top will pop up and can removed. 4 - Remove burner control knobs and the top and bottom screws holding the control panel on. 5 - Remove the two guide pins at each front corner and the screws at the rear of the burner box, 6 total. 6 - Gently raise the burner box and disconnect the gas line to the control valve then unplug the igniter. Reverse order to install me valve. It's a little tricky getting the screws back in the burner assemblies but you can grip the burner well enough to pull it up and install the screws. Don't over tighten screws they will strip easily.