Porter Cable Sander Polisher Seals and Gaskets

Fix Number

FIX10166528

Manufacturer Part Number

151553-00

Genuine OEM replacement part, this item is sold individually. The 151553-00 Dust Seal/Brake is a dual propose part. It is a Dust Seal to help prevent dust and debris from entering the motor assembly. It also acts as a Brake to keep the sanding pad at lower RPM so the sander will work properly. It is a good idea to replace this part when you are replacing the sanding pad.

Fix Number

FIX10166041

Manufacturer Part Number

144974-00

This is a genuine DeWALT replacement part to be used in sanders. The dust seal fits in the platen. It prevents dust from entering the device. This item is available as an individual replacement part, and may require a screwdriver to install.

Fix Number

FIX10179429

Manufacturer Part Number

56194-00

O-rings are made to contain thousands of PSI pressure by creating a seal between two or more parts. O-ring measurements are defined by the inside diameter and the thickness. There are many causes for O-ring failure. The most common among power tools are: • The O-ring has ragged, tattered edges. These are commonly caused by pressure spikes which shear off tiny "bites" from the O-ring, or caused by clearance gaps. • One or both sides of the O-ring appear rough and slightly flattened. Commonly caused by a contact surface that is too rough, contains grit, or is too smooth to allow lubrication. • The O-ring is flattened on both sides and may have a "ring" split along its length. Commonly caused by excessive pressure or heat. • The O-ring has a pitted or cracked surface, and is often flattened on both sides. Caused by temperature exceeding O-ring capacity. • The O-ring is covered in small surface cracks. Caused by exposure to ozone, UV rays, and air pollution. Excessive seal stretching (greater than 5%) causes similar cracking.

Fix Number

FIX10184200

Manufacturer Part Number

700871-00

This is an original DeWALT replacement part. The O-ring is designed by the manufacturer for use in random orbit sanders. This part is made of flexible rubber, and is used to seal the connection between the clamshell set and the baffle. You may require a screwdriver or Allen wrench when replacing this item. This part is sold individually.

Fix Number

FIX12455032

Manufacturer Part Number

801852

This is an authentic manufacturer sourced replacement seal that is commonly utilized on electric power tools. It has multiple uses depending on the equipment, for correct location and use of this hardware please make sure to check appropriate diagrams of your tool. Over time these seals tend to shrink, become brittle and crack eventually requiring replacement. Please note this durable rubber seal is sold individually.

Fix Number

FIX12504733

Manufacturer Part Number

848537

Fix Number

FIX18985858

Manufacturer Part Number

697029

Fix Number

FIX12496752

Manufacturer Part Number

848524

Fix Number

FIX10109952

Manufacturer Part Number

841133

This is an authentic OEM component from Porter Cable. The seal (early models) is made for use in several belt sanders, and is sold individually. This metal item helps to secure the bronze bearing. A screwdriver, hex key and pliers may be helpful with making making installation.

Fix Number

FIX18986750

Manufacturer Part Number

804566

This is a genuine replacement part sourced directly from the manufacturer. The gasket is found in Porter Cable belt sanders. This part is made of plastic, and is used to seal the connection between the cover and the frame. You may require a screwdriver or Allen wrench when replacing this item. The gasket is sold as an individual replacement part.