Router Seals and Gaskets

Fix Number

FIX16676215

Manufacturer Part Number

050056-00

This is an authentic manufacturer sourced replacement part that is specially produced for use with Dewalt and Black and Decker power tools. The purpose of an o-ring is to provide and air-tight seal between two connected parts, over time it may deteriorate and crack eventually requiring replacement.It is made of durable rubber material and it is sold individually.

Fix Number

FIX10260152

Manufacturer Part Number

2610913683

This item has been sourced from the original manufacturer to be used with rotating multi-tools from Dremel. The durable plastic cap is used to cover and support the carbon brushes. The cap allows you to access the brushes without having to disassemble the motor housing. This item is sold as a pair.

Fix Number

FIX10174987

Manufacturer Part Number

50049-00

It is a genuine manufacturer-sourced replacement part that is supplied for use with DeWALT and Black and Decker power tools. This is a special o-ring which is utilized to provide an air-tight seal between connected pieces, for the correct application make sure to check appropriate diagram of your model. Over time o-rings tend to deteriorate and crack eventually requiring a replacement to maintain the proper seal. It is a high-quality component which is made of durable rubber material and is sold individually.

Fix Number

FIX10337855

Manufacturer Part Number

45310

Fix Number

FIX10141729

Manufacturer Part Number

213030-4

Fix Number

FIX10169050

Manufacturer Part Number

323711-26

O-rings are made to contain thousands of PSI pressure by creating a seal between two or more parts. O-ring measurements are defined by the inside diameter and the thickness. Of the many causes for O-Ring failure, the most common among power tools are: • <u>Extrusion and Nibbling</u> - The O-ring has ragged, tattered edges. These are commonly caused by pressure spikes which shear off tiny "bites" from the o-ring, or caused by clearance gaps. • <u>Abrasion</u> - One or both sides of the o-ring appear rough and slightly flattened. Commonly caused by a contact surface that is too rough, contains grit or is too smooth to allow lubrication. • <u>Over Compression </u> - The O-ring is flattened on both sides and may have a "ring" split along its length. Commonly caused by excessive pressure or heat. • <u>Heat Hardening</u> - The O-ring has a pitted or cracked surface, and is often flattened on both sides. Caused by temperature exceeding o-ring capacity. • <u>Weather/Ozone Cracking</u> - The O-ring is covered in small surface cracks. Caused by exposure to ozone, UV rays and air pollution. Excessive seal stretching (greater that 5%) causes similar cracking.

Fix Number

FIX10082016

Manufacturer Part Number

560746001

Fix Number

FIX10340325

Manufacturer Part Number

96065

Fix Number

FIX18985851

Manufacturer Part Number

695620

Fix Number

FIX10086305

Manufacturer Part Number

9760010