Black and Decker Reciprocating Saw Power Cords

★★★★★

★★★★★

1 Review

Fix Number

FIX10169875

Manufacturer Part Number

330072-98

This power cord is used for power tools and some of the following tools: electric drills, reciprocating saws, jig saws, biscuit joiners, and routers. The power cord is made for double insulated tools and is a two-wire cord with two prongs, but it does not need a ground wire. If there are cuts in the cord insulation, intermittent power during operation, or damaged and bent prongs, then replacing the power cord will solve the problem. The tools needed for this repair are a Phillips screwdriver, small screwdriver, wire cutters/strippers, crimping tool, and terminal (ring or spade). Repair tip: During installation, remember that new cord wires must go correctly into wire terminals. Also, to avoid pinching when the tool case is put back into place, remember to route cord and wires in the right path.

Fix Number

FIX17061542

Manufacturer Part Number

N918736

This cord protector is a genuine DeWalt replacement part and is sold individually. Cord Protectors are designed to slide onto your cord and fit securely at the end, where it's firm rubber will protect the base of the cord from getting bent and pinched, which can expose the wires and become a safety hazard.

Fix Number

FIX10169655

Manufacturer Part Number

330005-01

This is a cord protector, but it is also called a strain relief, and it is used with multiple power tools. This part is made of firm rubber to protect the cords from being pulled out or exposed, which would be a safety hazard. Over time the strain relief can develop cracks and break into pieces. This part is black and 4 inches long. The smallest end has a diameter of 0.5 inches. When completing this repair tuck in all wires to avoid pinching.

Fix Number

FIX10173549

Manufacturer Part Number

448557-98

This replacement 10 foot power cord is specially produced for Black and Decker and Dewalt power tools. It is designed to connect to a standard US outlet supplying power to the tool. Please note one rubber insulated cord is included per order, the cord protector is not included it is sold separately. To complete this repair you will need a screwdriver.

Fix Number

FIX10169921

Manufacturer Part Number

330081-08

This cord is a genuine DeWalt replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. Power Cord Specifications: • 2 Prongs • 2 Wires • 16 Gauge • 8 Feet Long

Fix Number

FIX10166272

Manufacturer Part Number

148481-00

This is a replacement part sourced directly from the manufacturer for Dewalt drills. The cord protector is used to protect the cord from getting damaged. To install the cord protector requires no tools, simply slide the cord into place through the cord protector. This part is made of rubber and is sold individually.

Fix Number

FIX10169879

Manufacturer Part Number

330073-98

This replacement power cord is a genuine OEM sourced item that is specially designed for use with Black and Decker and Dewalt power tools. Its purpose is to supply electricity from a standard U.S. outlet to the tool. This high quality rubber insulated cord is included per order, please note the cord protector is not included, it is sold separately.

Fix Number

FIX12402079

Manufacturer Part Number

330081-98

This is a genuine part which is supplied directly by the original equipment manufacturer and is used with Porter Cable, Black and Decker, and Dewalt impact wrenches and drywall screwdrivers. When plugged into the wall, the power cord transfers power to the unit. This part is made of flexible plastic and metal, it is also sold individually. For installation, you will need a screwdriver to remove any covers or shrouds, and a pair of needle nose pliers to aid you.

Fix Number

FIX10112288

Manufacturer Part Number

891461

Fix Number

FIX10173966

Manufacturer Part Number

479984-00