Pressure Washer Bearings

Fix Number

FIX8911051

Manufacturer Part Number

192980GS

This fuel valve with bushing fits a variety of outdoor equipment and allows the fuel to smoothly flow into the gas engine. The bushing part is pressed into the hole provided in the fuel tank and the fuel valve is pressed through the bushing to reach the inside of the fuel tank. If your fuel valve is broken then it best to replace it. Refer to the manual provided by the manufacterer for more information on the part and installation instructions. Safety tip: remember to wear gloves and be cautious when removing fuel from the tank.

Fix Number

FIX10020947

Manufacturer Part Number

9.165-355.0

This is an original Karcher replacement part. The grooved ball bearing is designed by the manufacturer for use in pressure washers. This part comes in three metal pieces, and is used to allow the wobble shaft to spin freely. You may require an Allen wrench or hex key when replacing this item. This part is sold individually.

Fix Number

FIX10020429

Manufacturer Part Number

9-0010

Fix Number

FIX10020431

Manufacturer Part Number

9-0029

Fix Number

FIX10136780

Manufacturer Part Number

62-0175

Fix Number

FIX10020426

Manufacturer Part Number

9-0005

Fix Number

FIX8938184

Manufacturer Part Number

262001

Fix Number

FIX12620259

Manufacturer Part Number

570554001

This authentic item is supplied directly from the original equipment manufacturer for use with pressure washers and generators. The wear pad is made of hard rubber and attaches to the foot bracket with a washer and a bolt. It may require a wrench during replacement if the part becomes broken. The pad is sold individually and helps to reduce vibrations and cushion the bracket.

Fix Number

FIX9306915

Manufacturer Part Number

796961

This is sold as a kit that contains the bushing and the seal. These are genuine replacement parts sourced from the original manufacturer for use with engines, snowthrowers, lawn mowers, and blower-vacuums made by Briggs & Stratton and Toro. When replacing these items a set of pliers might be required during the installation process. They are made of metal and plastic and will require replacing if they become broken.

Fix Number

FIX9980735

Manufacturer Part Number

570554002

It is an authentic component which is specially designed for Homelite and Ryobi pressure washers. This is an identical replacement for a damaged or a missing wear pad that was installed on a new unit. It attaches to the front frame and it helps to support the equipment. This high-quality wear pad is sold as an individual item. Check the diagrams for your model to ensure the proper repair procedure.