Paint Sprayer Seals and Gaskets

Fix Number

FIX17016773

Manufacturer Part Number

417341

The container seal is a genuine item that is supplied by the original equipment manufacturer for use with Wagner paint sprayers. It fits between the spray gun assembly and the suction tube. The seal is made of a thick Styrofoam and helps to keep the paint from leaking out of the spray gun. This item is sold individually.

Fix Number

FIX10158515

Manufacturer Part Number

115099

Fix Number

FIX10054429

Manufacturer Part Number

XA003300AV

This is the genuine OEM supplied replacement part that is used on Campbell Hausfeld air compressors. A gasket is a mechanical seal which fills the space between the cylinder and the cylinder head. It is recommended to replace gaskets when replacing the cylinder or doing a maintenance repairs on the unit to ensure proper seal. Over time the material may get compressed and crack eventually requiring replacement. Please note this durable composite material gasket is sold individually.

Fix Number

FIX10157876

Manufacturer Part Number

103413

It is an authentic OEM supplied replacement part that is specially designed for Graco sprayers. This o-ring provides an air tight seal for the pump, please make sure to check appropriate diagrams for correct location and use of this item. Note that one durable rubber o-ring is included per order.

Fix Number

FIX10498206

Manufacturer Part Number

800-332

A genuine item that is supplied directly from the original equipment manufacturer for use with Titan and SprayTECH pumps. This special component is utilized to provide an air-tight seal between connected pieces, over time it may get compressed and begin to crack eventually requiring a replacement. It is a high-quality part which is made of durable rubber material and is sold individually.

Fix Number

FIX10243411

Manufacturer Part Number

SK206401SJ

These are Campbell Hausfeld replacement parts directly sourced from the manufacturer for use in spray guns. They are made of a felt material and go between the canister and the top assembly. A screwdriver may be needed when replacing these parts. This is sold as a kit that contains three seals.

Fix Number

FIX10158709

Manufacturer Part Number

117559

This is an authentic Graco replacement part that has been sourced from the original manufacturer and is intended to be used with paint sprayers. The o-ring is used to seal the connection between the suction hose and the pump assembly. The o-ring is priced as a single item, please note two may be needed.

Fix Number

FIX12614606

Manufacturer Part Number

122486

Fix Number

FIX10497238

Manufacturer Part Number

560-038

This is a genuine item that is supplied by the original equipment manufacturer for use with Titan airless sprayers. It is a special component that is utilized to provide a tight seal for the manifold filter, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality item is made of durable rubber and is sold individually.

Fix Number

FIX12646213

Manufacturer Part Number

16Y425

This O-ring, also known as a gasket, is a genuine OEM replacement part designed for use in air sprayers. It is a rubber seal with a diameter of approximately 1.5 inches, that sits between the pump and filter to prevent air and paint leakage between the two mating parts. If the ring is lost, worn out, damaged, or has lost elasticity, it will need to be replaced. A faulty O-ring will result in issues such as leaking, low pressure, inconsistent spray patterns, and friction damage between the filter and pump. To replace the O-ring, open the sprayer housing and twist the pump off. Carefully pry the old O-ring off and clean the mounting area to ensure a good seal for the new ring. Place the O-ring over the filter and apply light pressure until it is flat against the surface. Reassemble the equipment to complete your repair.