OEM Makita Charger Parts & Accessories

Fuse

$6.15

Fix Number: FIX10153756
Manufacturer Part Number: 652782-6

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Makita chargers. The purpose of the fuse is to protect the electrical power systems against excessive currents which are caused by short circuits, ground faults, etc. Keep in mind this high-quality component is sold individually. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this part.

Fuse, Dc18Rc

$6.15

Fix Number: FIX16391251
Manufacturer Part Number: 652802-6

Varistor

$10.38

Fix Number: FIX10153459
Manufacturer Part Number: 647321-5

This item is available as an individual replacement part. The varistor is made out of metal and plastic. During replacement, it may require a screwdriver to help install this part correctly. It will require replacing if it breaks. This genuine item is supplied by the original equipment manufacturer for use with Makita rapid battery chargers.

Installation Instructions

Dennis from OROVILLE, CA

Battery placed in charger for perhaps 15 seconds, then all power ceased to charger - no lights

Replaced fuse in charger with no success. Replaced varistor in charger, again with no success. Checked that 120 volts being delivered to circuit board - OK. Out of ideas - to the garbage the charger goes. Read more...

Scirocco Fan

$25.10

★★★★★

1 Review

Fix Number: FIX10153290
Manufacturer Part Number: 638499-5

It is a high quality item that is specially produced for Makita chargers. This is an authentic OEM sourced item that helps to prevent the charger from overheating. One durable plastic scirocco fan is included per order, replacing it is a simple task that should only require a screwdriver.

Guide Plate

$4.13

Fix Number: FIX10148533
Manufacturer Part Number: 343421-6

Cap 13

$6.15

Fix Number: FIX10146256
Manufacturer Part Number: 286255-3

This authentic manufacturer-sourced component is specially designed for Makita battery chargers. The cap is secured over the screw that holds the circuit board. It is an identical replacement for a missing or a damaged cap that was installed on a new unit. Refer to the diagram for your specific model for the exact location and the correct application of this part. This high-quality hardware is made of durable plastic and is sold as an individual item.