OEM Milwaukee Hoist & Winch Parts & Accessories

Snap Ring

$6.51

Fix Number: FIX10127145
Manufacturer Part Number: 34-60-1400

Genuine Milwaukee replacement part, this item is sold individually. This Snap Ring is used in a number of Milwaukee Tools as shown below. Snap Rings are used in various parts of tools. They are usually installed on a shaft to keep a bearing or a gear from moving. They are also used in other applications depending on what tool you are working on. This is an example of an external Snap Ring.

3/8 Split Lock Washer

$6.51

Fix Number: FIX10119290
Manufacturer Part Number: 06-97-0070

Shading Coil

$11.75

Fix Number: FIX10122528
Manufacturer Part Number: 22-51-0230

Included in part number 14-04-0085

Latch Kit Assembly

$30.75

Fix Number: FIX10120985
Manufacturer Part Number: 14-47-0145

A bent, broken, or missing hook latch can let loose rigging leave the hook when the line goes slack. This spring-loaded latch closes the hook opening but does not carry the load or make poor rigging safe. Before replacing it, inspect the hook for cracks, twisting, wear, or a widened opening. Confirm fit with the complete hoist model and rated hook. Remove the hoist from service, lower every load, disconnect and lock out power, and have a trained person install the kit. Test the latch and complete the required hoist inspection before lifting again.

Ball Bearing

$7.72

Fix Number: FIX10116877
Manufacturer Part Number: 02-04-1030

This part is compatible with assorted Milwaukee power tools including band saws, circular saws, and chain hoists. It is a genuine OEM part. A bearing's purpose is to hold moving parts in place while allowing them to rotate smoothly and correctly. This reduces friction between the parts. Due to metal fatigue and wear, bearings are replaced fairly often. Sold individually.

1/4-20 Lock Nut

$6.51

Fix Number: FIX10118194
Manufacturer Part Number: 06-57-5000

It is a genuine manufacturer sourced replacement component which is produced for use with Milwaukee equipment. This special lock nut has multiple applications depending on the model of your unit. Please make sure to check the appropriate diagrams for the exact location and the correct installation of this part. Over time it may wear out or simply get lost eventually requiring a replacement. It is a high-quality lock nut is made of durable metal and is sold individually. You will need a wrench to secure or remove it.

Contact Assembly

$160.31

Fix Number: FIX10122644
Manufacturer Part Number: 22-58-0260

Unreliable lifting or lowering commands may come from damaged electrical contacts within a hoists pendant station. This contact assembly works with the control button to send the requested command through the hoists low-voltage control system. Inspect it for burned surfaces, loose terminals, broken insulation, corrosion, or signs of overheating. Similar problems may be caused by the pendant cable, button mechanism, contactor, or limit switch, so test the full control circuit first. Match the replacement to the exact catalog and serial details. Lower and unload the hook, lock out the power supply, photograph the wiring, and follow the service diagram. Complete an unloaded operational and limit-switch test afterward.