Drill Press Power Cords

★★★★★

★★★★★

3 Reviews

Fix Number

FIX10173396

Manufacturer Part Number

445338-00

This is a cord protector, also known as a strain relief, for your power tool. This part will slip into place at the end of your cord, snug against your power tool. The durable rubber will protect the base of your cord from being bent, pinched, or exposed. This part will eventually wear down and potentially crack or snap off, and exposed wire is a hazard. We recommend replacing the cord protector when damage is visible.

Fix Number

FIX10122663

Manufacturer Part Number

22-64-0121

This cord is a genuine Milwaukee replacement part and is sold individually. This cord is used on the Milwaukee tool listed below It is a 3 wire cord with 3 prongs and does need to be grounded to the tool.

Fix Number

FIX10131777

Manufacturer Part Number

44-76-0150

This is a Genuine OEM replacement Protector Grommet which is used on Milwaukee Power Tools. This part is made out of Rubber and is Sold Individually. It is important to have a cord protector on your tool to improve friction, seal cable and protect it from a potential damage. Replacing this item would differ based on your tool. • First you would need to gain access to internal connections of Power Cord by removing housing of your tool • Once you have disconnected Power Cord you would need to loop it through the Protector • Re-Connect Power Cord to your tool • Secure Cord Protector in the Housing opening and assemble your tool

Fix Number

FIX10169973

Manufacturer Part Number

36480-98

This cord is a genuine DeWalt replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. Power Cord Specifications: • 3 Prongs • 3 Wires • 18 Gauge • 10 Feet Long

★★★★★

★★★★★

1 Review

Fix Number

FIX10122659

Manufacturer Part Number

22-64-0076

This replacement cord is specially produced for Milwaukee power tools. This item is supplied directly from original equipment manufacturer. The purpose of a power cord is to deliver electricity from an outlet to the tool. This cord is rubber insulated and it is sold individually. Please note, the protector/grommet is sold separately. Replacing this cord is simple task that should only require a screwdriver. • Remove the housing screws • Separate housing pieces • Disconnect wires from the old cord • Remove old cord and secure the new one • Reassemble and test the unit

Fix Number

FIX10173377

Manufacturer Part Number

444518-98

This 10 ft. power cord is a genuine manufacturer sourced replacement part that is specially produced for Black and Decker and Dewalt power tools. It is used to supply electricity from a standard U.S. outlet to the tool. One durable rubber insulated cord is included per order, please note the cord sleeve protector is sold separately.

Fix Number

FIX10153859

Manufacturer Part Number

664754-9

This cord is a genuine Makita replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. Power Cord Specifications: • 3 Prongs • 3 Wires • 16 Gauge • 16 Feet Long

Fix Number

FIX10122754

Manufacturer Part Number

22-64-0950

Fix Number

FIX10078380

Manufacturer Part Number

089140300047

Fix Number

FIX10079385

Manufacturer Part Number

13302015B-3