Cordless Drill Springs and Shock Absorbers

Fix Number

FIX11929265

Manufacturer Part Number

N019351

The compression spring is part of the impact drivers chuck assembly. The spring is found over the anvil shaft and provides tension to pull the chuck collar back after a bit is removed. Over time this part can lose tension or become damaged. A failed compression spring will cause the collar to move freely, and the driver bit will come loose. This is an OEM official part and is sold individually.

Fix Number

FIX12527474

Manufacturer Part Number

N437890

This is an OEM authorized spring for an impact driver. It is sold individually. It is part of the bit holder assembly and works with other components to create pressure on the sleeve, helping to keep the bit in the holder. If this spring gets lost or stretches, it will need to be replaced. It has an approximate outside diameter of 0.545-inches, and the wire is about 0.030-inches.

Fix Number

FIX10185154

Manufacturer Part Number

871690

It is a genuine item that is supplied by the original equipment manufacturer for use with DeWALT and Black and Decker power tools. It is an identical replacement for a missing or faulty spring that was installed on a new unit, unfortunately, over time it will wear out or may begin to crack eventually requiring a replacement. Keep in mind this high-quality part is made of durable metal and is sold individually. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware.

Fix Number

FIX10143367

Manufacturer Part Number

233025-1

This is a Genuine OEM replacement part used on some Makita Power Tools. This is a Metal Spring and it is Sold Individually. Over time springs may loose its tension and may not function as intended. If this part is lost or damaged it must be replaced.

Fix Number

FIX10127907

Manufacturer Part Number

40-50-1090

This is an authentic Milwaukee replacement part manufactured for use with power tools. The special compression spring is used with a variety of different types of power tools. This spring is commonly used to allow flexibility between part assemblies and to prevent jarring between the part assemblies. This compression spring is sold as an individual replacement part, please see model diagram for part location and usage.

Fix Number

FIX10143244

Manufacturer Part Number

231951-8

Genuine Makita replacement part, this item is sold individually. This part is used on the tools listed below, to contain all of the part that are attached to the front end of the tool. Such as the Chuck assemblies on the the Impact Drivers and the Spindle Assemblies on the Screwdrivers.

Fix Number

FIX10143359

Manufacturer Part Number

233005-7

This is a Genuine OEM replacement part used on Makita drills and drivers. This is a metal spring and it is sold individually. Over time springs may lose its tension and may not function as intended. If this part is lost or damaged it must be replaced. To replace this spring a pair of pliers is needed.

Fix Number

FIX10143063

Manufacturer Part Number

231352-0

Fix Number

FIX11877708

Manufacturer Part Number

40-50-0027

This replacement spring plate is an authentic OEM part which is made for use with Milwaukee power tools. The spring connects to the switch lever allowing it to retract. Over time it may wear out or get damaged eventually requiring a replacement to ensure your tool functions properly. Note, this high-quality spring plate is made of durable metal and is sold individually. You will need a screwdriver to take the tool apart in order to remove the old part and secure the new one. Refer to the appropriate diagrams of your specific model for the exact location of this hardware.

Fix Number

FIX10188391

Manufacturer Part Number

N102647

This is an authentic replacement part sourced directly from the manufacturer. The terminal block tension spring is commonly found in DeWALT reciprocating saws, cut-off tools, and impact wrenches. This part is made of metal, and is used to apply tension to the battery assembly, to reduce the effects of vibration. You may require a screwdriver when replacing this item. The terminal block tension spring is provided as an individual replacement part.