Circular Saw Springs and Shock Absorbers

Fix Number

FIX10143551

Manufacturer Part Number

233376-2

This is a genuine Makita replacement part, it is sold individually. The 233376-2 Spring is part of the spindle lock system on the Grinders shown below. The reason for locking the spindle is so that you can remove and replace grinding wheels. The other parts need for the spindle lock system are part numbers. • 417771-6 Pin cap • 256486-8 Shoulder Pin • And 256486-8 O Ring.

★★★★★

★★★★★

2 Reviews

Fix Number

FIX10165739

Manufacturer Part Number

132254-07

This is a genuine carbon brush with the holder, sold as one part. If your equipment requires two carbon brushes and holders, you will need to add two to cart. The carbon brush and holder are responsible for transferring electric current to the spinning armature in the motor. If your equipment will not start, the most common reason for this is due to a worn brush. This repair has taken most of our customers less than fifteen minutes to complete and is considered easy to medium difficulty. For this repair you will need screwdriver.

Fix Number

FIX19507545

Manufacturer Part Number

1619X01792

Fix Number

FIX10127770

Manufacturer Part Number

40-50-0045

The metal guard spring attaches to the cover set and is priced individually. It is a genuine OEM sourced part which is specially designed for use with Milwaukee circular saws. This part may become bent or broken and will need to be replaced. A set of pliers may be needed when replacing the spring.

Fix Number

FIX10143204

Manufacturer Part Number

231806-7

Genuine Makita replacement part, this item is sold individually. The purpose of the 231806-7 Tension Spring is to raise and lower the telescoping lower guard. When you make a cut the Lower Guard will raise up inside of the upper guard, as you get to the end of your cut the Spring will cause the lower guard to return to it original position. The spring is attached to the Lower Guard and also to the upper Guard housing.

Fix Number

FIX10143218

Manufacturer Part Number

231839-2

Genuine Makita replacement part, this item is sold individually. The purpose of the 231839-2 Tension Spring is to return the Lower guard back to its original position after use. To attach the spring, one end is installed on the Lower Guard and the other end is installed in the Blade Case.

Fix Number

FIX10188378

Manufacturer Part Number

N100006

This item is sourced from the original manufacturer and is intended to be used with circular saws from DeWalt. The metal torsion spring attaches to the lower guard assembly. This item is used to keep the guard over the blade as it pivots back after the cut. This item is sold as an individual replacement part.

★★★★★

★★★★★

1 Review

Fix Number

FIX10143210

Manufacturer Part Number

231821-1

This item has been sourced from the original manufacturer to be used with circular saws from Makita. The metal spring is used to provide tension between the lower guard and the blade case. This item allows the guard to pivot through the cut and spring back over the blade after the cut. This item is priced as a single item.

Fix Number

FIX16313052

Manufacturer Part Number

253428-3

This part is available individually. The spring washer fits between the wing nut and the flat washer. This washer is small and will need to be replaced if it gets lost or if it breaks. It is made out of metal and no tools should be necessary when replacing this item. This is an OEM Makita part directly sourced from the manufacturer for use with saws, cutters, planers, drills, and trimmers.

Fix Number

FIX10127851

Manufacturer Part Number

40-50-0650

This is an authentic Milwaukee replacement part. The spring is designed by the manufacturer for use in circular saws. This part is made of metal, and is used to apply tension to the knob in the shoe assembly. No tools are required when replacing this item. Simply unscrew the knob so the old part can be removed and replaced. This item is sold individually.