Angle Grinder Springs and Shock Absorbers

Fix Number

FIX10143551

Manufacturer Part Number

233376-2

This is a genuine Makita replacement part, it is sold individually. The 233376-2 Spring is part of the spindle lock system on the Grinders shown below. The reason for locking the spindle is so that you can remove and replace grinding wheels. The other parts need for the spindle lock system are part numbers. • 417771-6 Pin cap • 256486-8 Shoulder Pin • And 256486-8 O Ring.

Fix Number

FIX11929644

Manufacturer Part Number

N263579

The spring fits between the lock button and the o-ring. This part is an OEM from DeWALT for use in angle grinders. Keep in mind this high-quality part is made of metal and sold individually. A screwdriver might be needed during the installation process. Over time this part may stretch or break and will need to be replaced.

Fix Number

FIX11929664

Manufacturer Part Number

N291619

The spring attaches to the guard lever release. This part is an OEM from DeWALT for use in angle grinders. This item is available as an individual replacement part. It may require an allen wrench and a set of pliers during installation. It is made of metal and will need to be replaced if it becomes broken.

Fix Number

FIX10127930

Manufacturer Part Number

40-50-1330

This is an authentic Milwaukee replacement part that has been sourced from the original manufacturer to be used with angle grinders. The metal spring fits into the gearcase and is used to provide compression for the spindle lock button. This item allows the button to be pressed and keeps it in the upright position when not pressed. The compression spring is available as an individual replacement part.

Fix Number

FIX17080088

Manufacturer Part Number

40-50-0386

Fix Number

FIX19500227

Manufacturer Part Number

1604652015

Fix Number

FIX10336574

Manufacturer Part Number

01468

This is a spring for your sander. It is known as a conical spring because it is cone shaped, and coiled. It is comparable to a compression spring because it stores energy by absorbing shock, and then releasing it, to maintain the force between two surfaces. The spring is a part of the muffler assembly in your sander. The muffler assembly reduces the noise coming from your machine. Over time the spring may lose tension and need replacing. If you are replacing your muffler assembly, or similar parts, we also recommend replacing the spring for an even wear.

Fix Number

FIX10153793

Manufacturer Part Number

654197-3

This authentic part is supplied by the original equipment manufacturer and is specially designed for use with Makita angle grinders. It is an identical replacement for a faulty or a missing ring terminal that was installed on a new unit. Unfortunately, over time it will wear out and it may begin to stretch eventually requiring a replacement. This high-quality component is made of durable metal and is sold individually. Make sure to refer to the appropriate diagrams for your model to ensure the proper repair procedure. A screwdriver will be needed to replace this hardware.

Fix Number

FIX17065394

Manufacturer Part Number

14-46-0241

Fix Number

FIX18698653

Manufacturer Part Number

672592001

This item is a genuine Ridgid replacement part that is intended to be used with angle grinders. The metal spring is a direct replacement of the original spring that was installed onto the grinder when new. This part is used to keep the handle lock button upright in the lock position and to allow the button to be compressed when rotating the handle to a different position. The spring is priced as a single item.