Part Location Diagram of 308164004 Homelite IMPELLER ASSEMBLY
See part B-12 in the diagram
( Grid squares measure 1x1 inch )

IMPELLER ASSEMBLY 308164004

Rated by 1 customers 

?

Easy 

30 - 60 mins 

Ratings submitted by customers like you who bought this part.

?
$6.98
In Stock
Fix Number:
FIX18783717
Manufacturer #:
308164004
Manufactured by:
Homelite

Product Description

Questions and Answers

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Installation Instructions Provided by Fix customers like you.

Average Repair Rating: 3.3 / 5.0, 1 reviews.
  • 1
Sort by:
Sorry, we couldn't find any existing installation instruction that matched.
Customer:
David from CANONSBURG, PA
Parts Used:
308164004
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
While the blower was in use, something got too close to the air inlet, and the impeller took in foreign material that damaged the impeller blades.
Turn the blower on its side, there are approximately (14) T15 Torx screws that are about 1" long that all need to be removed. Some are recessed inside further which requires a T15 driver with approximately 4" of depth to reach them. After all screws are removed, the two outer cases split apart right down the middle. The blower nozzle d oes need to be removed prior to separation, and also there are a few Ryobi factory stickers that will need to be sliced down the middle of them to allow the cases to separate. Once the case is removed, you will see the motor with the impeller attached. The motor can be slid out of its housing far enough to be able to remove the impeller. To remove the impeller, use an adjustable wrench of the end opposite the impeller, there are flat areas on the impeller shaft where an adjustable wrench can be tightened onto to hold it steady. With the adjustable wrench in place, the impeller can easily be removed by unscrewing it from the thread end of the shaft. Be careful because my impeller threads were reverse threaded to allow for the impeller to stay tight. I recommend using permanent strength thread lock on the threads of the shaft prior to tightening it down onto the motor shaft. Pay close attention to install the impeller in the same direction as the old one was removed. After this step, reassemble in reverse order.
6 of 6 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
  • 1

Model Compatibility

This part works with the following models:
Fix Number: FIX18783717
Manufacturer Part Number: 308164004
Brand Model Number Description
Ryobi RY40401 Leaf Blower / Vacuum - Blower