Ariens Lawn Tractor Hardware

Fix Number

FIX9982804

Manufacturer Part Number

584953901

This part is the replacement washer head screw for your lawn tractor. It is black in color and is approximately an inch and a half in length. This self-threading screw is most commonly used for securing the mandrel housing to the mower deck of your lawn tractor. The main reason you would need to replace this part is if the old screw is damaged or missing. This part is sold individually and is a genuine OEM part sourced directly from the manufacturer.

Fix Number

FIX9143890

Manufacturer Part Number

812000029

This manufacturer-approved ring clip is found in various lawn and garden equipment models. A ring clip is used as a fastener that secures components or assemblies onto a shaft or housing (such as part of a mower wheel or steering assembly). When it is installed, the part that is visible acts as a shoulder, holding the specific component or assembly together. This very small metal ring clip (approximately 1-inch by 1-inch) is sold individually.

Fix Number

FIX9008998

Manufacturer Part Number

532121749

This is a flat metal washer found in various models of lawn mowers and is sold individually. This flat washer can have various functions depending on the equipment; however, its general purpose is to spread the load under a bolt or screw. It also helps to reduce heat and friction as the fastener is tightened. This repair may require a screwdriver or socket wrench, depending on the fastener for your model. This is a single flat washer; the fasteners are sold separately.

Fix Number

FIX9020856

Manufacturer Part Number

532193003

This manufacturer-approved bolt and washer assembly is for lawn tractors. Wear work gloves to protect your hands when installing this part.

Fix Number

FIX9022497

Manufacturer Part Number

532409149

This is a genuine hex flange locknut for a lawn mower. It attaches to the carriage bolt (sold separately), fastening the axle assembly braces in place. This part is sold individually, however most models require three. For this repair you will need a wrench set.

Fix Number

FIX9286886

Manufacturer Part Number

532187690

This is an OEM lawn mower deck mandrel spacer washer, sold individually. It measures approximately 43/64-Inches in diameter, 1-1/8-Inches outer diameter, and 5/32-Inches thick (these measurements are approximate). In general, washers help to spread load, can provide insulation such as electrical, and can also help to prevent galvanic corrosion.

Fix Number

FIX9015920

Manufacturer Part Number

532188967

Fix Number

FIX9020881

Manufacturer Part Number

532194209

This is an OEM bowtie cotter pin for lawn tractors. It is sold individually. This part is made of metal material, so over time, this metal can corrode or rust, especially if the lawn tractor is exposed to elements on a regular basis. It should be checked regularly and replaced every so often. Before you begin this repair, the ignition switch needs to be turned off, the key removed, the mower deck should be in the lowest position, and the clutch actuator lever needs to be off. When installing the new pin, make sure the washer is in place before sliding the pin into position. This repair should only take a few minutes.

Fix Number

FIX8925657

Manufacturer Part Number

222698S

Fix Number

FIX9144108

Manufacturer Part Number

819191912

This part includes one clear zinc washer. It is sourced directly from the original manufacturer and is an exact replacement for the original part. The function of this part is to distribute weight evenly between connected components. It helps to create a firmer more secure seal. This standard piece of hardware has various uses depending on the equipment. If this part is warped or damaged and is no longer creating a tight grip, it will need to be replaced.