Little Wonder Hedge Trimmer Parts
Start With Your Model Number
Popular Little Wonder Hedge Trimmer Parts
Fix Number FIX11826311
Manufacturer Part Number A369000480This is a single OEM fuel filter that has been approved by the manufacturer, ensuring the highest quality. It is compatible with numerous types of outdoor power equipment, such as blowers, trimmers, edgers, chainsaws, etc. This is a very important maintenance part that should be replaced on a regular schedule. Its purpose is to remove contaminants that could clog up the carburetor, which should also be regularly inspected. For this simple repair, slide the new fuel filter onto the fuel line and use a screwdriver to place the clamp tightly over the nipple.
Fuel Line Grommet
Fix Number FIX8859978
Manufacturer Part Number 13211546730This is a fuel line grommet, and it is used with various lawn and garden equipment. This part prevents leaking fuel and fumes. The grommet is placed in the fuel tank to seal the opening area where the fuel line and the fuel tank connect. A worn grommet is a safety hazard because it will cause fuel to leak from the tank. We recommend when replacing it to also replace the fuel line. Before starting this repair make sure to drain the fuel from the tank, and remove the spark plug.
Fuel Tank Vent
Fix Number FIX9183121
Manufacturer Part Number A356000031This check valve or the fuel tank vent is connected to the fuel tank in the following products: hedge trimmer, leaf blower/vacuum, chainsaw, edger, engine, tiler, auger, water pump, chipper shredder, sprayer, and brush cutter. The check valve allows air into the fuel tank to prevent vacuum when the fuel is being fed through the fuel line. Tip: if the vent is clogged, your engine may stall. Usually, the vent line is connected to a fuel grommet that is installed on the fuel tank. The tools needed for this installation are: needle-nose pliers and a small slotted screwdriver. Remember to wear work gloves to protect hands. Refer to the manual for an accurate repair guide.
Fix Number FIX9148697
Manufacturer Part Number 90050000005This nut is used for a variety of handheld gardening tools. The nut has multiple applications depending on the tool you are using. Refer to the diagram provided by the manufacturer for installation instructions and nut location in a specific tool. This lock nut is used to resist loosening when threaded onto a bolt. *Please note: this part is sold individually. The measurements are: 5mm.