MTD Edger Parts

This is a Belleville washer, and it is used with various lawn and garden equipment around your home. This part has an inner diameter of 0.340 inches and an outer diameter of 0.872 inches. The convex shape of the Belleville washer acts like a spring, which is why they are often used in high load bearing situations.

This is a drive belt and it is used on various outdoor lawn equipment. This part is made of rubber and is sold individually. It measures to be 35.80 inches by 0.5 inches. This part drives the transmission, which propels the wheels on your machine. Pro tip, clean off the pulleys before installing this part for a longer lifespan. We recommend inspecting your belt periodically as they wear out quickly, depending on usage.

This lock washer is used to resist the loosening of bolted joints. Repair tip: It is difficult to install the lock washer in a tight place or when the bolt/screw is pointing down. This lock works with the following appliances: Lawn tractor, tiller, chipper, shredder, lawn mower, snow blower, leaf blower/vacuum, log splitter, edger, hedge trimmer, and engine. Refer to the manual provided by the manufacturer for repair instructions.

This carriage bolt fits a variety of tools and is sold individually. The square area under the head of the bolt is created to fit into a square hole in your tool. The hole makes sure to restrain the bolt and prevents it from turning when the nut is secured or tightened.

This star knob specifically fits a variety of lawn mowers and is used to secure both the lower and upper handles of your lawn mower. If your knob is worn out or loose, then replacing it will solve your problem. No tools are required for this repair. For installation instructions and more information on the part, refer to the manual provided by the manufacturer. This knob is secured with a carriage bolt, which is sold separately. *Please note: this knob is sold separately as well.

This is a plastic bushing for your lawn equipment. It fits onto the side of your fuel tank, and holds the fuel fittings so they do not touch sharp metal. This part is made of plastic, and will eventually wear out. When that happens, you must replace it. Before making this repair, we recommend letting your machine cool, and draining the gas tank.