Edger Hardware

Fuel Line Grommet This is a fuel line grommet, and it is used with various lawn and garden equipment. This part prevents leaking fuel and fumes. The grommet is placed in the fuel tank to seal the opening area where the fuel line and the fuel tank connect. A worn grommet is a safety hazard because it will cause fuel to leak from the tank. We recommend when replacing it to also replace the fuel line. Before starting this repair make sure to drain the fuel from the tank, and remove the spark plug.

Return Grommet This is a return grommet for your lawn and garden equipment. This part creates an airtight seal to prevent fuel leaking from your machine. We recommend installing both the grommet and the return fuel line together. Place the return fuel line inside the grommet and install both into the fuel tank.

Clip This is a clip for a variety of lawn and garden equipment. The clip is made of a durable metal, and is 6.5mm in diameter. This part is most commonly used to clamp tubes and hoses in place. The clip is sold individually.

Clip

Nut M8 Flange This is a hex nut flange for your lawn and garden tools. It is size M8, meaning it has an 8mm inner diameter, and a 1.25 thread pitch. The hex nut has a washer like base to ensure the nut stays tight. This is most commonly used in chainsaws.

Wing Bolt

Cotter Pin

Nut-Hex 5/16-18 This nut is mostly used in lawn tractors and snow blowers and is in different locations in the machine, depending on appliance. It is made from metal and measures to 5/16 inches for the diameter and a thread count of 18. Tip: Remember there are different nuts used in the machine, be sure you are ordering the correct part. The tool needed for this repair is a wrench. *Please note: this part is sold individually. Refer to the diagram provided by the manufacturer for instructions.

Nut-10 x 1.25

Screw 4x16