Graco Parts

Fix Number

FIX10158515

Manufacturer Part Number

115099

Fix Number

FIX10158709

Manufacturer Part Number

117559

This is an authentic Graco replacement part that has been sourced from the original manufacturer and is intended to be used with paint sprayers. The o-ring is used to seal the connection between the suction hose and the pump assembly. The o-ring is priced as a single item, please note two may be needed.

Fix Number

FIX10158931

Manufacturer Part Number

124249

Fix Number

FIX10160034

Manufacturer Part Number

179733

The sleeve seal fits between the gun body and the filter. This item is available individually. It is a genuine replacement part sourced from the original manufacturer for use with Graco spray guns. When replacing this item a set of pliers might be required during the installation process. It will require replacing if it becomes broken.

Fix Number

FIX10157898

Manufacturer Part Number

104361

This genuine item is supplied directly from the original equipment manufacturer for use with Graco paint sprayers. The o-ring fits between the housing and the filter and is made out of plastic. During the installation process, a screwdriver may be needed. This is available as an individual replacement part.

Fix Number

FIX12614606

Manufacturer Part Number

122486

Fix Number

FIX12646213

Manufacturer Part Number

16Y425

This O-ring, also known as a gasket, is a genuine OEM replacement part designed for use in air sprayers. It is a rubber seal with a diameter of approximately 1.5 inches, that sits between the pump and filter to prevent air and paint leakage between the two mating parts. If the ring is lost, worn out, damaged, or has lost elasticity, it will need to be replaced. A faulty O-ring will result in issues such as leaking, low pressure, inconsistent spray patterns, and friction damage between the filter and pump. To replace the O-ring, open the sprayer housing and twist the pump off. Carefully pry the old O-ring off and clean the mounting area to ensure a good seal for the new ring. Place the O-ring over the filter and apply light pressure until it is flat against the surface. Reassemble the equipment to complete your repair.

Fix Number

FIX12606643

Manufacturer Part Number

120776

Fix Number

FIX10161410

Manufacturer Part Number

244035

Fix Number

FIX10158921

Manufacturer Part Number

123849

It is a genuine item which is supplied directly from the original equipment manufacturer for use with Graco sprayers. It is an identical replacement for a missing or damaged component that was installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality compression spring is made of durable metal and is sold individually.