This thermal fuse limiter is used in dryers to monitor the temperature and make sure it does not overheat. The thermal fuse has a limit of 220 degrees Fahrenheit before the heating element and power are cut off. If your thermal fuse has blown or is damaged then your dryer will not start, can over heat, or take too long to dry. It is important to replace the fuse to solve the above problems. For this repair, you will need a Philips screwdriver, putty knife, and a needle nose plier. As a safety precaution, remember to unplug dryer from power source to avoid electrocution when installing this part. Refer to the manual provided by the manufacturer for further instructions.
-
Works with the following brands:
Frigidaire, Kenmore, Gibson, Kelvinator
-
Works with the following products:
Dryer, Washer Dryer Combo
-
Fixes the following symptoms:
Too hot, Not Heating, Won’t Start
-
Part# 134120900 replaces these:
AP2108182, 1489053, 146062-000, 3205659, 5303209192
- Works with the following brands:
- Frigidaire, Kenmore, Gibson, Kelvinator
- Works with the following products
-
Dryer, Washer Dryer Combo
- Fixes the following symptoms
- Too hot, Not Heating, Won’t Start
Part Number Cross Reference
- Part# 134120900 replaces these:
-
AP2108182, 1489053, 146062-000, 3205659, 5303209192