Broil Element - 2400W

We followed the video provided. We unplugged the unit, removed the back plate of the range, unhooked the wiring to the baking and broiling elements. Then from the front of the range removed the screws holding the broiling element up and removed the screws to the broiler element and baking element. We then installed the new elements, reatt ... Read more ached the wiring and put the back plate back on. Extremely easy task. The video was extremely helpful. Thank you so much. It made the job very easy. It was my sister's range and she did it all. What does that say.

After removing the burnt up element, pulled the stove out from the wall. Removed the back panel and reconnected the wiring. The original element had brackets attached to each side to hold it to the top of the oven. The new one did not so I had to reuse the old, original wire for support.

unplugged range, remove back, disconnected element, removed screws holding element in place, replaced with new element and repeated steps in reverse. It's works great.

When removing element you have to remove top two side brackets that hold it in. Two screws and slide out. Remove the back two screws against back wall holding element in place, wiggle out ends with connection to wires. It's a tight fit so don't pull. Once out leave enough wire exposed with connection or you will have a hard time getting t ... Read more hem back out. Just remove old element with a tug at connectors. Replace new part by sliding connectors together. Wiggle it back into hole in back of range and screw each side in the predrilled hole and plate. Put the two brackets back in on top to hold in place. Put straight end in first then screw the looped ends or it won't work tighten both in with the two screws and it's in.

Element came the next day !!!! When I turned on the broiler, the stench was terrible. The smoke from the preservative on the element took about 30 minutes to dissipate. If the temperature outside were warmer we could have opened the doors and windows. Could have used some pre-cleaning options.

I undid the screws holding the element inside the oven but, going back with it, found that I wanted to be sure that the prongs were making good contact so, I removed the back cover of the stove and presto, all connected the right way and pushed the insulation away from the prongs. Stove working like a charm.