Support Clip

I followed the very clear directions given at the site: unplug the stove; remove the screws at each front corner holding the glass top onto the stove frame; pull the top forward and unplug the wire harness in the back; turn the top upside down on a padded table; unscrew the hold-down clamps for the burner; remove the wires from the old bu ... Read more rner and put onto the new burner (one of them was a bit rusty so I used the brush to clean off that connector so that it would slide onto the spade on the burner easily); remove the burned out burner and put the new burner with wires connected into place; tighten down the hold-down clams (I had to replace one of the clamps with a new one because the original one was quite corroded); put the top back onto the stove and reconnect the wiring harness; push the top into place and replace the hold-down screws in the corners; plug the stove back in and try the burner; all burners now heating as expected.