Upper Dish Rack Roller

I checked carefully, from all sides and angles, where the part was to be positioned before I removed the existing broken part. The new part snapped easily into place.

1. Unsnap existing Rack Wheel Assembly. 2. Remove rubber end stops from Rack Wheel Guide. 3. Roll wheel of new Rack Assembly into Guide. 4. Snap body of Wheel Rack Assembly onto the sides of the Rack where you removed the broken one. 5. Stand back and inspect work, you are done!

I removed the plastic ends from the steel track that the wheels run in. I then pulled the rack part way out leaving the rear wheels in the track with the front of the rack resting on the door. The old assembly was very easy to snap out and the new assembly was very easy to snap in the rack. The final process was to pick up the front of th ... Read more e rack and line up the wheels and slide them in the steel track and replace the plastic ends in the steel track.

Remove the end stops from both upper roller tracks. Pull out upper rack and place upside down on counter. Push on locking tabs with two fingers and push up on the adjuster assembly. Twist the assembly slightly to get it out from between the two section of the rack. Reverse the procedure to install the adjusters.