Electronic Control Board

Easly removed the cover behind the control panel by removing the six screws. Once it is off it is just a couple of snap clips that hold the inside cover and control board on. Once you get the control board out it is as easy and pulling all the plugs out and plugging them back in to the new board. All the colors are labled but there are on ... Read more ly six so i just unplugged it from the old and directly into the new, one at a time. Once they are all plugged in, snap the board into place, snap the back cover on and screw it all back together. Once that was done I had to run a reset to get it to recognize the new board. Thats as easy as pressing two buttons back to back a few times but it all depends on which model you have. After it ran through the 5 min reset cycle. Everything works just like new.

Turn off electric power. Open door and remove the top 6 Torx screws that hold the control panel to the door. You have to wiggle the panel to get over the door latch. Once the panel is free turn it over and remove the cover on the box that contains the board by pushing on the tabs that are marked. All of the wiring connections are plug ins ... Read more .