Lower Gear Case - White

Four screws on transmission case, two on the circuit after taking a picture to make sure I plugged wires in right later. Three screws for the base and two for the motor. Thoroughly cleaned the gears to make sure no metal bits stayed in reassemble. New grease and put it back together. Unfortunately the main shaft was be ... Read more nt and I didn't think to check it, not sure why... (reminder: if you run it hard enough to bust the case... check the shaft) Had been mixing heavy dough at a high speed. Had been doing it for years and must say it held up well for the stress I had put on it. Anyways, it had broken around the bushing holding the main shaft, in turn the gears weren't tight and eventually stripped. After getting the parts, I was a little concerned about them not being tapped but the pilot holes were drilled well and there was no problem.