This suspension spring is a genuine OEM replacement part for a variety of washers and washer-dryer combos. The primary purpose of the suspension spring is to support the outer tub and keep the tub steady during loads that could cause an unbalance. If this part breaks, is worn down, or has stretched out and lost its spring, it could cause the load to be off-balance which can lead to excessive shaking, moving, noise, and leaks. This part is approximately 2 inches in length when compressed, made of durable metal, and is sold individually. For this repair, you will need a 1/4 nut driver, putty knife, flat blade screwdriver, and a pair of needle-nose pliers. Before you begin, disconnect the power, fill hoses, and drain hose to give you easy and safe access (drain hose may release some water, have a small container or towel near by). Your appliance contains 3 suspension springs, so keep this in mind if you need to order multiple of this part. We suggest you purchase several at a time, as they can be very useful to have on-hand.
-
Works with the following brands:
Whirlpool, Kenmore, KitchenAid, Roper
-
Works with the following products:
Washer, Washer Dryer Combo
-
Fixes the following symptoms:
Shaking and Moving, Leaking, Spinning Issues
-
Part# WP63907 replaces these:
AP6010168, 63907
- Works with the following brands:
- Whirlpool, Kenmore, KitchenAid, Roper
- Works with the following products
-
Washer, Washer Dryer Combo
- Fixes the following symptoms
- Shaking and Moving, Leaking, Spinning Issues
Part Number Cross Reference
- Part# WP63907 replaces these:
-
AP6010168, 63907