Rubber Water Delivery Tube

Simple installation. Took a couple of minutes. No clamps to replace. It just slips on. Does require a slight bit of pressure, but it’s not hard to put in at all.

Step 1. Remove old tube by first removing the funnel shaped fitting from the back end of the tube.
Step 2. Pull tube towards the back to remove.
Step 3. Apply liquid soap to the inside half inch of each end of new tube.
Step 4. Lay tube into position in the bracket it lays on.
Step 5. Push tube toward front of dishwa ... Read more sher onto molded fitting.
Step 6. Push funnel shaped fitting into other end of tube. Done.

It was very easy to fix, just put the new tube in warm water and pushed it right on. Took less than 5 minutes to repair.

This was an exceptionally easy installation. The only hitch was when we attempted to put the hose on it was too tight. We used a little dish soap on the inside of each end and it went right on.