Part Location Diagram of AEM69493807 LG Drain Hose Assembly
See part A130 in the diagram
( Grid squares measure 1x1 inch )

Drain Hose Assembly AEM69493807

Works With Model LDS5811ST-01!

Rated by 2 customers 

?

Really Easy 

30 - 60 mins 

Ratings submitted by customers like you who bought this part.

?
$53.58
In Stock
Fix Number:
FIX11732679
Manufacturer #:
AEM69493807
Manufactured by:
LG
Works With Model LDS5811ST-01!

Product Description

Replacement dishwasher drain hose. Per the manufacturer if the drain hose being replaced does not have the vent tube going to the water inlet assembly a new water inlet will be needed.

Questions and Answers

Be the first to ask our experts a question about this part!

Installation Instructions Provided by Fix customers like you.

Average Repair Rating: 3.8 / 5.0, 2 reviews.
  • 1
Sort by:
Sorry, we couldn't find any existing installation instruction that matched.
Customer:
Gregory from Denver, CO
Parts Used:
AEM69493807
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers
broken drain hose
Disconnect washer, pull out and remove the left side panel. Undo the twist ties holding the drain hose in position. Set the washer on it's right side Remove the two screws holding the bottom metal panel. Undo the clamp which holds the hose onto the pump. There is a white plastic insert around the hose that secures it to the washer fram e where the hose exits the washer. This can be removed by pinching the two arms of the insert to remove it from the hose and the washer frame. You can now remove the hose. Reverse the process for installation. The procedure is quite easy.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Richard from Moosup, CT
Parts Used:
AEM69493807
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers, Wrench (Adjustable)
Drain split at back of unit and started leaking
I shut off the water supply and the power. removed lower panel and disconnected the electrical and water supply. Unscrewed under counter support brackets and pulled dishwasher out from counter. Tipped unit on right side (placed on foam pad) unscrewed bottom panel and left side panel. detached old hose from pump with adjustable pliers and removed hose bracket from back panel just squeeze ends together and it comes out. Attached new hose to pump with squeeze fitting and had to plug short black hose that came with the new hose that would not fit anywhere on my unit (must be for newer models). Then just reconnected everything in reverse and pushed unit back under counter and reconnected water and electrical. Then connected the new drain hose to the drain with ring clamp (not supplied) and turn the water and electricity back on and ran a test load (all was good). reinstalled the bottom panel.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
  • 1