Crossover tube for the center burner

Remove the grills from the cooking bay. Crossover tube required removing phillips head screws in the cooking bay of the grill holding down the two outboard gas burner tubes. Sprayed with penetrating oil and let sit for 15 minutes before unscrewing due to corrosion. Using nut driver, remove 2 bolts holding support bracket for other end of ... Read more tubes above the LP gas tank. By removing this bracket, all 3 burner tubes could be moved freely in the cooking bay to remove the old part and install the new part. New part has a bracket that slips over the middle tube while its ends insert into holes in each of the 2 outboard tubes. Insert the two phillips head screws removed earlier to hold the ends of the burner tubes in position. Then, being careful to insert the opposite ends of the 3 burner tubes in the gas orifices, re-install the support bracket using a nut driver to fasten it to the side of the grill cooking bay. Flavorizer bars are set evenly spaced above the burner tubes beneath the grills. Replace the grills once the bars have been set into position.