10323862-1-M-Delta-426023950005-Trunnion
Part Location Diagram of 426023950005 Delta Trunnion
See part 126 in the diagram
( Grid squares measure 1x1 inch )
10323862-1-S-Delta-426023950005-Trunnion Part Location Diagram of 426023950005 Delta Trunnion

Trunnion 426023950005

$ 66.96
No Longer Available

No Longer Available

Sorry, this part is No Longer Available at Fix.com, which means:

  • The part is no longer sold by the manufacturer.
  • The manufacturer does not stock any substitute parts to replace this one and therefore, unfortunately, we cannot obtain or recommend a substitution for this part.
  • We cannot obtain the part through any other means.

Our call center and online agents are, unfortunately, unable to help you locate this part, but you may still be able to find the part elsewhere. We recommend:

  • Typing your part number into a search engine and checking to see whether another company might stock it.
  • Searching online stores like eBay for your part number.
  • Visiting a local appliance store or parts dealer to see if they have this part in stock.
  • Contacting a local technician, who may be able to repair your existing part or replace it with their own solution.
  • Contacting the manufacturer of your appliance directly to check for their recommendations.
Fix Number:
FIX10323862
Manufacturer #:
426023950005
Manufactured by:
Delta

Product Description

This is an OEM replacement part designed for use with Delta Band Saws. A trunnion is a protrusion used as a mounting and/or pivoting point. The purpose of this item is to allow the Saw Table to be Tilted to a desired degree. This part is made out of Die Cast Metal and it is Sold Individually. This Trunnion has a Metal Scale attached to it. This part is secured in Trunnion Support Assembly with Cap Screw, Clamp Shoe and Adjusting Knob all of which are Sold Separately. It is attached to the Table with Two (2) other screws. When replacing this Trunnion you would need a Wrench to remove Screws holding the Table. Once the table is lifted you will have access to old Trunnion. Use another Wrench to remove the Screw and Knob that hold it to the Support Assembly and you will be able to remove old Trunnion. Make sure there is no dirt or debris on the Support Assembly and place a new Trunnion in place. Place the Table back in place and tighten all the necessary screws.

  • Works with the following brands:
    Delta
  • Works with the following products:
    Band Saw, Saw