Timer

Remove the dryer cord or shut off breaker, then take off all of the knobs from the appliance front, remove the six screws from the back, lift up keeper in lower right corner and twist out of place, move wires from old to the new timer, push thru hole in appliance front and twist into place. Replace the six screws, knobs, turn breaker back on or put cord back into place, test timer operation, and I was done in 15-20 minutes.

Open the box for the replacement part and plugged wire for wire and closed the cover back on and plugged into dryer outlet and it worked great

I followed your instructions and it made it so easy! Thank you for your help!!

After reading the instructions posted by others, I carefully removed the control panel with a screw driver. I removed the timer from the back by twisting one side up and the other side down leaving all the wired attached. I removed the wires one at a time with pliers and replaced them in te corresponding place on the new timer. Each wire has a letter. I placed the timer back by twisting one side up and one side down in reverse of how I took it off. I replaced the control panel and pluged in the dryer(always remove the powersource first). It wored perfectly, my husband was very surprised that I had done it so fast and without him.

Hardest thing was moving the dryer and the "stuff" that was in the way in order to access the rear of the dryer. Remove and replace one wire at a time. If you do this , it is a "piece of cake".