Watch the install video
419402-1-M-Frigidaire-134120900 -Thermal Limiter - Limit 220
Part Location Diagram of 134120900 Frigidaire Thermal Limiter - Limit 220
See part 33 in the diagram
Replacing your Frigidaire Dryer Thermal Limiter - Limit 220
419402-1-S-Frigidaire-134120900 -Thermal Limiter - Limit 220 360 view
( Grid squares measure 1x1 inch )
419402-1-S-Frigidaire-134120900 -Thermal Limiter - Limit 220 419402-2-S-Frigidaire-134120900 -Thermal Limiter - Limit 220 419402-1-S-Frigidaire-134120900 -Thermal Limiter - Limit 220 360 view
Part Location Diagram of 134120900 Frigidaire Thermal Limiter - Limit 220 Replacing your Frigidaire Dryer Thermal Limiter - Limit 220

Thermal Limiter - Limit 220

Rated by 5 customers 

?

Easy 

30 - 60 mins 

Ratings submitted by customers like you who bought this part.

?
$29.15
In Stock
Fix Number: FIX419402
Manufacturer #: 134120900
Manufactured by: Frigidaire
  • Product Description

    This thermal fuse limiter is used in dryers to monitor the temperature and make sure it does not overheat. The thermal fuse has a limit of 220 degrees Fahrenheit before the heating element and power are cut off. If your thermal fuse has blown or is damaged then your dryer will not start, can over heat, or take too long to dry. It is important to replace the fuse to solve the above problems. For this repair, you will need a Philips screwdriver, putty knife, and a needle nose plier. As a safety precaution, remember to unplug dryer from power source to avoid electrocution when installing this part. Refer to the manual provided by the manufacturer for further instructions.

  • Works with the following brands
    Frigidaire, Kenmore, Gibson, Kelvinator
  • Works with the following products
    Dryer, Washer Dryer Combo
  • Fixes the following symptoms
    Too hot
  • Part Number Cross Reference
    Part# 134120900 replaces these:
    AP2108182, 1489053, 146062-000, 3205659, 5303209192
1 Installation Video
1 Related Part Questions and Answers
5 Installation Instructions Model Compatibility
Product Description Part Videos Questions and Answers Related Parts Installation Instructions Model Compatibility

Product Description

This thermal fuse limiter is used in dryers to monitor the temperature and make sure it does not overheat. The thermal fuse has a limit of 220 degrees Fahrenheit before the heating element and power are cut off. If your thermal fuse has blown or is damaged then your dryer will not start, can over heat, or take too long to dry. It is important to replace the fuse to solve the above problems. For this repair, you will need a Philips screwdriver, putty knife, and a needle nose plier. As a safety precaution, remember to unplug dryer from power source to avoid electrocution when installing this part. Refer to the manual provided by the manufacturer for further instructions.

  • Works with the following brands:
    Frigidaire, Kenmore, Gibson, Kelvinator
  • Works with the following products:
    Dryer, Washer Dryer Combo
  • Fixes the following symptoms:
    Too hot
  • Part# 134120900 replaces these:
    AP2108182, 1489053, 146062-000, 3205659, 5303209192

Videos For installing this part.

Replacing your Thermal Limiter - Limit 220

Replacing your Thermal Limiter - Limit 220

Questions and Answers

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

High Limit Thermostat
$88.99
Part Number: FIX446428
This high limit thermostat has a limit of 260 degrees Fahrenheit. Meaning that it will cut out when the internal dryer temperature reaches 260. This thermostat cuts back in when the temperature drops by 70 degrees Fahren...
$88.99
In Stock

Installation Instructions Provided by Fix customers like you.

Average Repair Rating: 3.3 / 5.0, 5 reviews.
  • 1
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
  • Customer:
    Jimmy from Mullins, SC
  • Parts Used:
    134120900, 131553900
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Screw drivers
No heat
Watched the provided video and followed the written diagrams for my model dryer.
3 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
  • Customer:
    George B. from Ringgold, GA
  • Parts Used:
    134120900
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Pliers, Screw drivers
dryer would not dry anything. The heating unit would not stay on.
First unplug the unit from the power source. You must disassemble the dryer to get to the cycling thermostat. Using a Philips screwdriver, remove the panel below the dryer, then you must remove the control panel just above the first panel you removed. Both of these pieces are held in place with 2 screws each. The control panel also has 2 clips that hold it in place, bit you can use a stiff putty knife to separate it from the dryer. The next thing is to remove the remaining front panel which supports one side of the drum. The top panel must be removed first which will allow you to remove the remaining front panel. The next thing is to reach in below the drum and slip the drive belt off the motor by pushing the idler tensioner to relax the belt. You can remove the drum by lifting up the drum from its place. A quick jerk will dislodge the drum from its place. The cycling thermostat is located on the back panel on the left side, held on by 2 screws. remove the 2 wires and the 2 screws remove the bad thermostat. Repeat these instructions in reverse order to complete the job.
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
  • Customer:
    James from Palm Coast, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers, Screw drivers
No Heat and error on front panel after about 2 minutes after running
removed 2 rear screws, removed top panel. Removed 2 top screws and 2 internal screws, disconnected electrical connections and removed front panel. removed drum guide. Disconnected drive belt, removed drum. removed 4 screws from rear, removed the heating element assembly. Cleaned the entire bottom section of the dryer. Installed new heating element assembly, installed thermal limiter and control thermistor, reassembled the dryer. Dryer has been working great!
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
  • Customer:
    Jared from Trevose, PA
  • Parts Used:
    134120900
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Screw drivers, Socket set
dryer was overheating
I followed the video, removed front cover, kept drum in place, which made removing screws harder, but I managed well enough
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
  • Customer:
    Dave from New Port Richey, FL
  • Parts Used:
    134120900
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Pliers, Screw drivers
Dryer was getting too hot and shutting itself off for safety reasons
Watched the video. Wasn't accurate for my stackable, but gave an insight where the thermal limiter can be found. Took off top of dryer and there it was. Did not have to remove drum. Easy fix for this job, works like new.
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
  • 1
Model Compatibility
This part works with the following models:
Fix Number: FIX419402
Manufacturer Part Number: 134120900
Brand
Model Number
Description
Frigidaire
41749012890
Dryer - Residential, Electric
Frigidaire
41749022890
Dryer - Residential, Electric
Kenmore
41761722511
Washer Dryer Combo - Laundry Center
Kenmore
41761723511
Washer Dryer Combo - Laundry Center
Kenmore
41761732810
Washer Dryer Combo - Laundry Center
Kenmore
41761732811
Washer Dryer Combo - Laundry Center
Kenmore
41761733810
Washer Dryer Combo - Laundry Center
Kenmore
41764182300
Dryer
Kenmore
41769042990
Dryer
Kenmore
41769042991
Dryer
Kenmore
41769052990
Dryer
Kenmore
41769052991
Dryer
Kenmore
41780032990
Dryer
Kenmore
41780042990
Dryer
Kenmore
41780042991
Dryer
Kenmore
4178005291
Dryer - Kenmore Dryer Model 417.8005291 (4178005291, 417 8005291) Parts
Kenmore
41780052990
Dryer
Kenmore
41780052991
Dryer
Kenmore
41780142000
Dryer
Kenmore
41780412700
Dryer
Kenmore
41781042000
Dryer
Kenmore
41781042001
Dryer
Kenmore
41781052000
Dryer
Kenmore
41781052001
Dryer
Kenmore
41781142000
Dryer
Kenmore
41781142001
Dryer
Kenmore
41782042100
Dryer
Kenmore
41782042101
Dryer
Kenmore
41782042102
Dryer
Kenmore
41782052100
Dryer