Frigidaire/Frigidaire_Thumb/6SLAUZTK.gif
See part 33 in the diagram
Replacing your Frigidaire Dryer Thermal Limiter - Limit 220 play video
( Grid squares measure 1x1 inch )

Thermal Limiter - Limit 220

$ 11.89   In Stock
Fix Number: FIX419402
Manufacturer #: 134120900
Manufactured by: Frigidaire

Product Description

This thermal fuse limiter is used in dryers to monitor the temperature and make sure it does not overheat. The thermal fuse has a limit of 220 degrees Fahrenheit before the heating element and power are cut off. If your thermal fuse has blown or is damaged then your dryer will not start, can over heat, or take too long to dry. It is important to replace the fuse to solve the above problems. For this repair, you will need a Philips screwdriver, putty knife, and a needle nose plier. As a safety precaution, remember to unplug dryer from power source to avoid electrocution when installing this part. Refer to the manual provided by the manufacturer for further instructions.

Videos For installing this part.

Replacing your Thermal Limiter - Limit 220

Replacing your Thermal Limiter - Limit 220 play video

Installation Instructions Provided by Fix customers like you.

Average Repair Rating: 3.3 / 5.0, 5 reviews.
    Sort by:
    Sorry, we couldn't find any existing installation instruction that matched.
    • Customer:
      Jimmy from Mullins, SC
    • Parts Used:
      134120900, 131553900
    • Difficulty Level:
      Easy
    • Total Repair Time:
      30 - 60 mins
    • Tools:
      Screw drivers
    No heat
    Watched the provided video and followed the written diagrams for my model dryer.
    3 of 3 people found this instruction helpful.
    Was this instruction helpful to you?
    Thank you for voting!
    • Customer:
      George B. from Ringgold, GA
    • Parts Used:
      134120900
    • Difficulty Level:
      A Bit Difficult
    • Total Repair Time:
      30 - 60 mins
    • Tools:
      Pliers, Screw drivers
    dryer would not dry anything. The heating unit would not stay on.
    First unplug the unit from the power source. You must disassemble the dryer to get to the cycling thermostat. Using a Philips screwdriver, remove the panel below the dryer, then you must remove the control panel just above the first panel you removed. Both of these pieces are held in place with 2 screws each. The control panel also has 2 clips that hold it in place, bit you can use a stiff putty knife to separate it from the dryer. The next thing is to remove the remaining front panel which supports one side of the drum. The top panel must be removed first which will allow you to remove the remaining front panel. The next thing is to reach in below the drum and slip the drive belt off the motor by pushing the idler tensioner to relax the belt. You can remove the drum by lifting up the drum from its place. A quick jerk will dislodge the drum from its place. The cycling thermostat is located on the back panel on the left side, held on by 2 screws. remove the 2 wires and the 2 screws remove the bad thermostat. Repeat these instructions in reverse order to complete the job.
    2 of 2 people found this instruction helpful.
    Was this instruction helpful to you?
    Thank you for voting!
    • Customer:
      James from Palm Coast, FL
    • Difficulty Level:
      Really Easy
    • Total Repair Time:
      15 - 30 mins
    • Tools:
      Pliers, Screw drivers
    No Heat and error on front panel after about 2 minutes after running
    removed 2 rear screws, removed top panel. Removed 2 top screws and 2 internal screws, disconnected electrical connections and removed front panel. removed drum guide. Disconnected drive belt, removed drum. removed 4 screws from rear, removed the heating element assembly. Cleaned the entire bottom section of the dryer. Installed new heating element assembly, installed thermal limiter and control thermistor, reassembled the dryer. Dryer has been working great!
    1 of 2 people found this instruction helpful.
    Was this instruction helpful to you?
    Thank you for voting!
    • Customer:
      Jared from Trevose, PA
    • Parts Used:
      134120900
    • Difficulty Level:
      A Bit Difficult
    • Total Repair Time:
      30 - 60 mins
    • Tools:
      Screw drivers, Socket set
    dryer was overheating
    I followed the video, removed front cover, kept drum in place, which made removing screws harder, but I managed well enough
    0 of 1 people found this instruction helpful.
    Was this instruction helpful to you?
    Thank you for voting!
    • Customer:
      Dave from New Port Richey, FL
    • Parts Used:
      134120900
    • Difficulty Level:
      Easy
    • Total Repair Time:
      30 - 60 mins
    • Tools:
      Pliers, Screw drivers
    Dryer was getting too hot and shutting itself off for safety reasons
    Watched the video. Wasn't accurate for my stackable, but gave an insight where the thermal limiter can be found. Took off top of dryer and there it was. Did not have to remove drum. Easy fix for this job, works like new.
    0 of 1 people found this instruction helpful.
    Was this instruction helpful to you?
    Thank you for voting!
      Model Compatibility
      This part works with the following models:
      Fix Number: FIX419402
      Manufacturer Part Number: 134120900
      Brand
      Model Number
      Description
      Frigidaire
      41749012890
      Dryer - Residential, Electric
      Frigidaire
      41749022890
      Dryer - Residential, Electric
      Kenmore
      41761722511
      Washer Dryer Combo - Laundry Center
      Kenmore
      41761723511
      Washer Dryer Combo - Laundry Center
      Kenmore
      41761732810
      Washer Dryer Combo - Laundry Center
      Kenmore
      41761732811
      Washer Dryer Combo - Laundry Center
      Kenmore
      41761733810
      Washer Dryer Combo - Laundry Center
      Kenmore
      41764182300
      Dryer
      Kenmore
      41769042990
      Dryer
      Kenmore
      41769042991
      Dryer
      Kenmore
      41769052990
      Dryer
      Kenmore
      41769052991
      Dryer
      Kenmore
      41780032990
      Dryer
      Kenmore
      41780042990
      Dryer
      Kenmore
      41780042991
      Dryer
      Kenmore
      4178005291
      Dryer - Kenmore Dryer Model 417.8005291 (4178005291, 417 8005291) Parts
      Kenmore
      41780052990
      Dryer
      Kenmore
      41780052991
      Dryer
      Kenmore
      41780142000
      Dryer
      Kenmore
      41780412700
      Dryer
      Kenmore
      41781042000
      Dryer
      Kenmore
      41781042001
      Dryer
      Kenmore
      41781052000
      Dryer
      Kenmore
      41781052001
      Dryer
      Kenmore
      41781142000
      Dryer
      Kenmore
      41781142001
      Dryer
      Kenmore
      41782042100
      Dryer
      Kenmore
      41782042101
      Dryer
      Kenmore
      41782042102
      Dryer
      Kenmore
      41782052100
      Dryer