SWITCH PRESSURE 100-135 PS 79027004117
Works With Model YN301PL!
$18.26
Special Order
- Fix Number:
- FIX18700132
- Manufacturer #:
- 79027004117
- Manufactured by:
- Ryobi
Works With Model YN301PL!
Jump to:
Product Description
-
Works with the following brands:Homelite, Ryobi
-
Works with the following products:Compressor
-
Part# 79027004117 replaces these:079027004117
- Works with the following brands:
- Homelite, Ryobi
- Works with the following products
- Compressor
- Part# 79027004117 replaces these:
- 079027004117
Part Number Cross Reference
Questions and Answers
Be the first to ask our experts a question about this part!
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
Sorry, we couldn't find a match for "".
Here's a guide for finding your model number.
Something went wrong. Please try again later.
Your Question Has Been Submitted!
Our experts will send you an email as soon as your question has been answered.
Related Parts Additional or alternate parts to consider.
Installation Instructions Provided by Fix customers like you.
- < Prev
- 1
- Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
- Customer:
- Richard from TUCSON, AZ
- Parts Used:
- 79027004117
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers, Wrench set
Compressor would not shut off when full pressure was achieved.
Went on line and got an IPB(illustrated parts breakdown). Make sure the unit is unplugged from power source. Remove screws holding the top and also removed the regulator knob. To remove knob you have to push screw driver through regulator knob label as it would not come off. Then I popped off the top it is snapped on the front by the regu
... Read more
lator knob so be careful as not to break the plastic holder on the front piece. Pressure switch is on top of tank removed wire from switch and used open end wrench to remove switch. Coated threads on switch with Teflon paste making sure not to get any in the little hole on switch. Installed switch and tighten with wrench. Reattached wires to switch and ran unit before reassembling the top. snapped top back in place and attached with screws.
Read less
2 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
- < Prev
- 1
- Next >
Model Compatibility
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.