9936698-1-M-Homelite-300953003-Ignition Coil 33 Cc
Part Location Diagram of 300953003 Homelite Ignition Coil 33 Cc
See part A10 in the diagram
9936698-1-S-Homelite-300953003-Ignition Coil 33 Cc 360 view
( Grid squares measure 1x1 inch )
9936698-1-S-Homelite-300953003-Ignition Coil 33 Cc 9936698-1-S-Homelite-300953003-Ignition Coil 33 Cc 360 view
Part Location Diagram of 300953003 Homelite Ignition Coil 33 Cc

Ignition Coil 33 Cc 300953003

$ 17.07
No Longer Available

No Longer Available

Sorry, this part is No Longer Available at Fix.com, which means:

  • The part is no longer sold by the manufacturer.
  • The manufacturer does not stock any substitute parts to replace this one and therefore, unfortunately, we cannot obtain or recommend a substitution for this part.
  • We cannot obtain the part through any other means.

Our call center and online agents are, unfortunately, unable to help you locate this part, but you may still be able to find the part elsewhere. We recommend:

  • Typing your part number into a search engine and checking to see whether another company might stock it.
  • Searching online stores like eBay for your part number.
  • Visiting a local appliance store or parts dealer to see if they have this part in stock.
  • Contacting a local technician, who may be able to repair your existing part or replace it with their own solution.
  • Contacting the manufacturer of your appliance directly to check for their recommendations.
Fix Number:
FIX9936698
Manufacturer #:
300953003
Manufactured by:
Homelite

Product Description

This replacement ignition coil also known as a magneto is a genuine OEM part. It is specially produced for Homelite and Ryobi chainsaws. It plays an important role, because it producing pulses of high voltage for the spark plugs. It is made out of metal with a rubber insulated wire and a spark plug boot. Please note replacing this module would differ based on your unit, however the basic steps would be the same. To complete this repair you will need screwdriver and a wrench set. • Remove the housing/covers from the unit • Remove the spark plug • Bind the cylinder • Remove the air filter cover and side cover • Remove the throttle cable from the carburetor • Disconnect the wires • Remove old ignition coil • Install new ignition coil • Set the gap • Reassemble and test the unit

  • Works with the following brands:
    Homelite, Ryobi
  • Works with the following products:
    Chainsaw