Washer Dryer Combo Legs and Feet

Leveling Foot It is important for your dryer to be properly leveled, as an unleveled one can cause excessive vibration and noise when operating, may not drain properly, and can cause excessive wear on various parts. A basic bubble level can be used to check that your appliance is good to go, and if it needs adjustments these leveling feet are what you need. There is a foot located at each corner of your dryer, that can be adjusted individually to ensure your appliance is balanced. If your dryer is wobbly, and has become noisy and excessively vibrating when it is running, one of these feet may be damaged and needs replacing. This OEM part is sold individually, so if you need to replace more than one foot be sure to order the correct quantity. They are approximately two inches in length, one inch wide, and are made of a threaded white plastic.

Foot, Front - Single Sold Individually.

Screw-In Plastic Leveling Leg This screw-in plastic leveling leg supports the washing machine. If your washer loses balance while it is tumbling, or makes loud noises, then it is best to replace the leveling leg to make sure the height is adjusted. Refer to the diagram provided by the manufacturer for further installation instructions and safety practices.

Rubber Foot Pad This foot pad is just over an inch in diameter. It is made entirely of rubber and is gray in color. This pad is intended for use with washers and some dryers.

Adjustable Levelling Leg

★★★★★

★★★★★

1 Review

Sold Individually. This adjustable leveling leg comes with a stop nut.

LEG ASSEMBLY This levelling leg is a genuine replacement part. It is used to help keep your washing machine stable and balanced. It helps support your appliance. It screws into the base of your washer, and you can thread it in or out to adjust the height. The foot on this leg is made of rubber, which helps with grip, stabilization, and vibration reduction. It is also hexagonal in shape, which allows you to more easily adjust it. This levelling leg features a locknut on the shaft which can be tightened against the bottom of your appliance, this will stop the leg from rotating while you are using your washer. This replacement is sold individually.

Leveling Foot & Nut Sold individually.

Rubber Leveling Leg Foot Pad This gray levelling leg foot pad is made of rubber and is just over an inch in diameter. Sold individually.

Leg

★★★★★

★★★★★

1 Review

This plastic adjustable dryer leg is used to support the weight and adjust the height of your dryer to keep it level. To install the leg, tip the dryer back and screw it into the bottom of your dryer unit. Please note that this dryer leg is sold individually.

Leveling Leg with Foot Sold individually.