Refrigerator Dispensers

Ice Guide

★★★★★

★★★★★

1 Review

When the ice dispenser in your fridge is activated, the ice guide helps to ensure the ice flows into your glass. This is a genuine OEM replacement ice guide that is made of clear plastic. If your ice maker is not dispensing ice, or the locking tabs have broken on your current guide, you may need to replace this part. The ice guide is located in the freezer door, and you will need to turn off the ice maker before beginning this repair. You should not need any tools to replace this part, but a flat blade screwdriver may be helpful in removing the old ice guide.

Dispenser Door Assembly or Flapper

★★★★★

★★★★★

1 Review

This is a genuine OEM replacement door flap for the ice maker in your refrigerator. This part goes by many different names, including door recess assembly, ice door assembly, dispenser door, ice chute door kit, ice chute door, or dispenser door flap. The flapper provides a seal that prevents warm room temperature air from entering the freezer. When the lever is pushed, this flap opens to dispense ice. Over time and with regular use the seal can fail, which can result in frost building up around the dispenser, or the ice maker will not be able to maintain a cool enough temperature to make ice. To complete this repair, you will need a Philips screwdriver and a small flat blade screwdriver. As you will be working with electrical components, please be sure to disconnect the power supply to your refrigerator before beginning this repair.

Refrigerator Dispenser Overflow Grille

★★★★★

★★★★★

1 Review

This grille is located on the bottom of the ice/water dispenser to catch the overflow. (Black)

Dispenser Door Solenoid Assembly The dispenser door solenoid is the part that controls the flapper door on your ice maker, allowing it to open and close when dispensing ice. If your ice maker is not dispensing ice or water, the door is not opening or closing, or the door is sweating, there may be an issue with the dispenser door solenoid. You can test this part with a multimeter to determine if it is faulty. If the part has failed it will need to be replaced. This part is a genuine OEM replacement for your dispenser door solenoid assembly.

Water Dispenser Actuator Once a glass is pressed against the actuator pad it will cause the dispenser to deliver ice or water when activated.

Ice Funnel

★★★★★

★★★★★

1 Review

This paddle, when your glass is pushed against it, activates the dispenser to release the ice through the funnel.

Water Dispenser Actuator Once a glass is pressed against the actuator pad it will cause the dispenser to deliver ice or water when activated.

Dispenser Door Recess Crank The door recess crank for your refrigerator is located inside the water dispenser assembly. To access this part, you will need to take apart the dispenser assembly. To do this, you will need a putty knife and a Phillips screwdriver. If your dispenser door will not close properly, or ice is not dispensing properly, you may have a damaged door recess crank. This part is made of white plastic and is sold individually.

Ice Dispenser Door Chute *Please note, this door chute is no longer being manufactured with a heater.

Ice Door Kit This kit includes the ice door, support, spring and delay. The heater ribbon is no longer attached - the heater is no longer needed.