Dacor Refrigerator Caps and Lids

Refrigerator Pantry Drawer Door Cover

★★★★★

★★★★★

3 Reviews

This genuine OEM part is a door cover for your refrigerator pantry drawer. It helps to maintain the proper temperature and humidity in the drawer by providing a seal when closed. Other names for this part include pantry drawer door or pantry drawer cover. No tools are required to replace this part. Simply release the locking tab and pull out the old cover one end at a time. Insert the new door cover, making sure the holes are properly secured around the hinge pins. The door cover should now open and close easily. To prevent damage to the new door cover, make sure that the snack drawer is fully pushed back into place before closing the cover, so that it can lay flat on the drawer.

Water Filter Cap - Black

★★★★★

★★★★★

1 Review

If the cap for your water filter has become damaged, this is an authentic OEM replacement part that is black in color. The cap is used to remove the old filter and insert the new one. Be sure to first push the release before attempting to pull the filter out, as the cap can become damaged otherwise. Without a cap, it can be difficult to reach the filter once it is in place.

Water Filter Cover This part is the replacement water filter cover for your refrigerator. The cover protects the water filter to prevent damage. If the water filter cover is cracked or missing, you should replace it. It is made of white plastic and is approximately 12 inches long, 5 inches wide at one end, and 4 inches wide at the other. To replace the water filter cover, simply depress the locking tabs and remove the old cover, then snap the new cover into place. This part is sold individually.

Cap, Water Filter (Black) This black water filter cap is located near the bottom kickplate.

Water Filter Cover This part is the replacement water filter cover for your refrigerator. It is made of white plastic and is approximately 13 inches long and 4 inches wide at the widest point. The water filter cover protects the water filter from damage while it is installed in the refrigerator. The main reason to replace the water filter cover is if it is cracked, damaged, or missing. This part is sold individually and is an OEM part sourced directly from the manufacturer.

Flipper This part is a replacement flipper or emitter cover for your refrigerator. It is made of white plastic and is approximately 3 inches by 2 inches. The flipper shields the emitter control board and houses the flipper cover for the emitter board. If your flipper is broken or missing, your ice maker may not make or dispense ice, and will need to be replaced. This part is sold individually and is an authentic OEM part sourced directly from the manufacturer.

Hinge Cover - Left Side - Apollo Gray Sold individually.

Top Right Hinge Cover - Apollo Grey

COVER- FZ

BUTTON- PL