Estate Microwave Parts

Estate Appliance Parts

Popular Estate Microwave Parts

Fix Number
FIX11747806
Manufacturer Part Number
WPA3073101
This 25-watt light bulb is a genuine OEM replacement part for a variety of appliances. The 120-volt incandescent bulb has a screw-in base and is used to light up the appliance when the door is opened. If the bulb has burnt out or is broken, it should be replaced. The light bulb is sold individually, but we recommend keeping spares on hand.
Microwave Locker
$13.60
In Stock
Fix Number
FIX3522838
Manufacturer Part Number
4026W2A019A
The locker, or door latch assembly fits to the inside of the microwave door, and keeps the door closed. If the door on your microwave oven doesn’t appear to close properly, you may have a problem with the door latch assembly. This locker is made of plastic and measures 7 inches long x 2 inches wide. If either of the hooks is broken or does not have any spring tension, you may need to replace the assembly.
Fixes these symptoms
Grease Filter
$26.73
In Stock
★★★★★
★★★★★
1 Review
Fix Number
FIX3650910
Manufacturer Part Number
W10208631A
This is a single grease filter for a microwave. Most microwaves have two filters, the other one being the charcoal filter, which is a different filter, sold separately, and has different maintenance instructions. The grease filter prevents grease from making its way into the ventilating hood. If you notice grease has started to accumulate in this area, the grease filter should either be cleaned or replaced. When cleaning the grease filter, be sure to use mild soap and water as harmful chemicals can cause damage, and this should be repeated monthly. This filter is located on the underside of the microwave. To remove it, slide the filter away from the tab area and drop out the filter. To install your new filter, place the end of the filter into the opening opposite to the tab area, lift the other end, and slide it into the tab area until it is secure.
Fixes these symptoms

Installation Instructions

Mark from North East, PA
Bulb burnt out
Removed the screw holding the bulb cover replaced the bulb. Reinstalled the cover and screw. Remove dirty grease filter replaced with new grease filter. Read more...
Door Switch - 3 Terminal
$9.40
In Stock
★★★★★
★★★★★
1 Review
Fix Number
FIX10057151
Manufacturer Part Number
W10727360
This is an authentic OEM door switch for your microwave. This switch is located behind the front panel, and works by making contact with the door hook, sending a signal that the door is closed and the microwave can now operate. If your microwave will not run when the door is closed, or the turn table continues to spin when the door is open, there is likely an issue with your door switches. You can use a multimeter to test which switch is faulty. Before beginning this repair, please be sure to disconnect the power supply to your microwave.
Fixes these symptoms
  • Doesn’t shut off
  • Door not closing properly
  • No heat
  • See more...

Installation Instructions

Steven from Fremont, CA
Circuit breaker and internal fuse blew upon opening door
Un-mount from cabinets. Remove top & side cabinet (single piece). Internal fuse is immediately accessible in High Voltage compartment (top). Interlock switches are mounted to a single assembly at the door latch. A single screw removes the entire assembly. I found it very difficult to remove the old switches from the interlock latch without breaking tabs on the latch, so, I purchased both switches AND a new interlock. Take pictures of the wire connections to the original installation before removing wires for reference when you re-install. Note that the failure of the fuse and circuit breaker worked in this situation as the fuse popped as I opened the microwave door. The microwave was NOT operating nor was the fan at the moment the fuse popped. A fuse which pops while the microwave is cooking is LIKELY NOT the interlock switches! Read more...
Microwave Door Interlock Switch
$30.85
In Stock
Fix Number
FIX2361111
Manufacturer Part Number
W10269458
The microwave door interlock switch prevents the microwave from starting if the door is open. If your microwave will not start when the door is closed, or it continues running if the door is opened, the door switch may need to be replaced. This microwave door interlock switch is a genuine OEM replacement part. We recommend that this part be installed by a qualified service technician. This is due to the testing the switch requires after installation, along with the potentially dangerous amount of charge the microwave capacitor can hold.
Fixes these symptoms
  • Doesn’t shut off
  • Door not closing properly
  • No heat
  • See more...

Installation Instructions

Steven from Fremont, CA
Circuit breaker and internal fuse blew upon opening door
Un-mount from cabinets. Remove top & side cabinet (single piece). Internal fuse is immediately accessible in High Voltage compartment (top). Interlock switches are mounted to a single assembly at the door latch. A single screw removes the entire assembly. I found it very difficult to remove the old switches from the interlock latch without breaking tabs on the latch, so, I purchased both switches AND a new interlock. Take pictures of the wire connections to the original installation before removing wires for reference when you re-install. Note that the failure of the fuse and circuit breaker worked in this situation as the fuse popped as I opened the microwave door. The microwave was NOT operating nor was the fan at the moment the fuse popped. A fuse which pops while the microwave is cooking is LIKELY NOT the interlock switches! Read more...
Light Bulb - 40W
$8.35
In Stock
★★★★★
★★★★★
3 Reviews
Fix Number
FIX2376034
Manufacturer Part Number
8206232A
To access the exterior lightbulb, the bottom panel of the microwave will need to be removed. It is secured in place with screws, so will require a Philips screwdriver to remove it. Screw the new light bulb directly into the light socket. If this is the first time you have replaced this light bulb, the old light bulb might be held in place with silicone. This silicone will need to be cut off using either a utility knife or dental floss before removing the light bulb. Once this silicone and old bulb has been removed, the replacement bulb can be screwed in its place.

Installation Instructions

Mark from North East, PA
Bulb burnt out
Removed the screw holding the bulb cover replaced the bulb. Reinstalled the cover and screw. Remove dirty grease filter replaced with new grease filter. Read more...
Microwave Turntable Motor
$43.21
In Stock
★★★★★
★★★★★
1 Review
Fix Number
FIX11755189
Manufacturer Part Number
WPW10466420
As per manufacturer this no longer comes with the Spacer.
Fixes these symptoms
R Ceramic Fuse 20 A
$36.00
In Stock
★★★★★
★★★★★
2 Reviews
Fix Number
FIX17629444
Manufacturer Part Number
W11707984
This part protects the microwave by shutting it off if there is an electrical surge.
Fixes these symptoms
Light Socket
$10.45
In Stock
Fix Number
FIX2342199
Manufacturer Part Number
W10210871
The light socket in your microwave houses the light bulb and connects it to the power source. The light bulb will screw into it, so the light bulb will be held in place. Be very careful when installing this part, and be sure to consult your manual before you begin this repair.
Fixes these symptoms

Installation Instructions

Daniel from Apollo Beach, FL
under hood light burned out
removed 10screws dropped panel . while I was there I also replaced bulb socket probably did not need to but I felt more comfortable doing so , also felt safer to do this. don't forget even when replacing only a light bulb unplug power from unit for safety sake. Read more...
Charcoal Filter
$15.70
In Stock
Fix Number
FIX1871363
Manufacturer Part Number
8206230A
This is a charcoal filter for an over-the-range microwave. It is designed to absorb grease before making its way into the vent, which could cause damage or build-up. It also helps to reduce odors while cooking on the stove top. If you notice the exhaust fan of your microwave is not functioning properly, it is likely the filter that needs to be replaced. To ensure it is working at peak performance it should be replaced every 6 months. This part is located inside the intake grille, which will need to be unscrewed and removed to reveal the filter. It is sold individually and measures approximately 5-inches by 5.375-inches. It is sourced directly from the manufacturer, ensuring it will be the correct fit for your model.
Fixes these symptoms

Installation Instructions

Newton from Brunswick, OH
Old vent grille cracked
Removed the two screws from the old vent grille and then removed the old vent grille.Since the old vent grille was off I removed the charcoal filter. Replace the old charcoal filter with a new charcoal filter it slide in place ( no screws ) and put the new grille vent in place and screwed it down. Read more...

Estate Microwave Appliance Types

Related Estate Microwave Parts

Popular Estate Microwave Models