Shop OEM Laundry Accessories Drawers and Glides

SLIDE Assembly

$25.10

Fix Number: FIX1517759
Manufacturer Part Number: WH16X10099

Smooth access to stored laundry supplies depends on drawer slides that remain straight and firmly mounted. Bent rails or loose hardware can make the pedestal drawer noisy, uneven, or hard to close. Check for overloading, trapped items, and damaged mounting points before ordering a replacement. Match the slide to the full pedestal and appliance model because side and length may vary. Disconnect power, empty and remove the drawer carefully, and do not loosen any hardware that secures the washer or dryer to the pedestal.

Drawer Slider - Right Side

$130.07

Fix Number: FIX3522885
Manufacturer Part Number: 4276ER0001A

A pedestal drawer that jams, tilts, or pulls out unevenly may have a damaged slide rail. This right-side replacement creates a steady track that lets the drawer travel below a laundry appliance. Proper support helps keep the drawer level and reduces rubbing against the pedestal frame. Inspect the rail for bends, broken stops, loose fasteners, or worn sliding areas. Confirm that the problem is on the right side before ordering, since the opposite rail has a different position. Remove all items from the drawer before service. Use protective gloves and keep the original screws or clips unless the equipment instructions direct you to replace them.

Drawer Slider - Left Side

$130.07

★★★★★

1 Review

Fix Number: FIX3522886
Manufacturer Part Number: 4276ER0002A

A pedestal drawer that sags toward the left or pulls out unevenly may have a damaged slider rail. This left-side replacement creates a steady track for the storage drawer and helps keep it level during use. Cracks, worn sliding surfaces, loose fasteners, or bent mounting areas can lead to sticking and poor alignment. Check both sides of the drawer so another damaged piece is not missed. Before service, remove all stored items and disconnect power to the laundry appliance. Follow the equipment diagram when moving screws, clips, or stops. After installation, open and close the empty drawer to check for smooth movement.