Dryer Drawers and Glides

Drum Bearing Slide - White

★★★★★

★★★★★

1 Review

This single drum bearing slide attaches to the outer-most side of the bearing. This part is also sometimes referred to as a drum slide, drum glide, or drum pad. It provides support to the front of the drum as it rotates. They are approximately 3-inches long, 1 inch wide and made from a durable white plastic. If your appliance starts making unusual sounds, is not drying clothes properly, or leaves marks on clothes, it may be time to replace this part. The dryer has 2 slides, which we recommend replacing at the same time, as they tend to wear out at the same rate. You will need to order 2 of this part to replace both drum bearing slides, since it is sold individually. Before you begin this repair, be sure to disconnect the power to the dryer.

Front Glide Kit

★★★★★

★★★★★

3 Reviews

This part is located on the front bulkhead of the dryer and helps the drum to rotate smoothly and quietly. If you notice a screeching or metal-on-metal noise while your appliance is operating, you may need to replace the front glides. This genuine OEM front glide kit comes with a blue plastic glide, a brown cork pad, and two metallic rivets. We recommend replacing both sets of glides at the same time, which will require the purchase of two kits. To complete this repair, you will need a Philips screwdriver and a 5/16 nut-driver to remove the front panel and the bulkhead of the dryer, a drill with a 1/8-inch bit to remove the old rivets, and a rivet tool to install the new ones. Please ensure that you disconnect the power supply to your dryer before beginning this repair. While you have the appliance opened, we recommend vacuuming out any lint and debris, and inspecting the felt around the bulkhead and replacing if necessary.

Upper Drum Glide

★★★★★

★★★★★

1 Review

If your dryer is noisy while tumbling, you may need to replace the drum glides. This genuine OEM part is found attached to the front panel of your dryer. It is used to reduce friction and allows the drum to rotate smoothly and quietly. Other signs you may need to replace the drum glide are if marks are being left on your laundry, or clothes are getting snagged. The drum glide is made of felt and nylon and includes the adhesive needed to attach the part.

Drum Slide This slide is sold individually. Some dryers require up to three of these slides . Be sure to check to make sure you order the necessary amount for your dryer.

Front Glide Kit This kit includes 2 glides (left and right), 2 pads with adhesive backing and 1 support brace.

Glide Bracket Kit This kit contains two glide brackets and four screws.

Drum Glide and Cushion Kit Pad has adhesive backing.

Slide

DRAWER DRAWER

Drawer