Tappan Dishwasher Hardware

Heating Element Brass Nut This heating element mounting nut is used in dishwashers and is used to hold the nut to prevent leaking. If your nut is damaged or you notice leaking from the dishwasher, then replacing this nut will solve this problem. The tools needed for this repair are a 1/2 inch wrench, 1/4 inch nut driver, and needle nose pliers. To repair, locate the two element heating nuts. Next, disconnect connecter wire and remove nut with wrench. Tip: when installing new nut, remember to add insulator sleeve back on. As a safety precaution, remember to disconnect the water supply line before beginning this installation. Also, unplug your dishwasher from the power source.

Kickplate Mounting Screw Sold individually.

Spring Linkage This linkage attaches to the door spring.

Door Catch Screw Sold individually.

Mounting Screw This screw is sold individually.

Pan Head Screw Sold Individually. Order quantity required.

Single Door Spring NOTE: Sold individually. This door spring is four and a half inches long. It is used for some dishwashers. These springs tend to wear out at the same rate, so you should replace both of your dishwasher door springs at the same time.

Kit - includes 8 Screws & 8 Washers Use for the upper rack rollers on the upper rack of your dishwasher.

Screw - White This screw is sold individually.

Element Grommet Sold individually.